Kaadas Smart Keypad User Manual
- June 9, 2024
- Kaadas
Table of Contents
Smart Keypad
User Manual
Smart Keypad
Smart Keypad is a Bluetooth 5.0 BLE accessory as a device of lock to input key and fingerprint, The Keypad is powered by 2*AAA battery.
Pairing Mode
Press and hold the “*” key for 5 seconds, until the green light blinks slowly,
and the buzzer beeps shortly one time.
One Touch Locking:
Press and hold Any key on keypad for 2 Seconds to lcok the door. Lock-Out If
you fail to unlock the door for 5 consecutive times using the PIN Key, you
lock will be shut-down for 3mins.
Support
2*AAA DC 3V
Bluetooth 5.0 BLE
Android 6.0 and iOS 13.3 or later
Indoor dry location use ONLY
Quiuick Start Guide
Preparation
- Download the Revolo App from Google Play or App Store.
Scan the QR code to download the Revolo APP
http://download.irevolo-app.com
- Successfully Added a WR Retrofit Smart lock.
Pairing the Keypad
-
Go to the device to a add accessory, “Settings” -> “Accessory” -> “Add Accessories” or “+”.
-
Hold the button “*” of the accessory for 5s to enter pairing mode.
-
Follow instructions from App and accessory prompts, then complete the process.
Tip: If you encounter any problems during the use of the product, please contact support@irevolo.com.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Canada Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s).Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>