QLT Vibropulse Pro Massage Device Instruction Manual

QLT Vibropulse Pro Massage Device

SAFETY WARNINGS

• Read the instruction manual before using the VIBROPULSO PRO for the first time.
• Always place the VIBROPULSE PRO on a flat surface
• Ensure that children do not use the VIBROPULSE PRO without adult supervision.
• Do not allow the VIBROPULSE PRO to make contact with water.
• If the power cable is damaged, is should be replaced with a special cable by the manufacturer or authorized technical service.
• Unplug the device after use
• As with any other physical exercise device, consult your doctor before you start using the VIBROPULSE PRO

This device may be used by children aged eight and over, by people with reduced physical sensory or mental abilities, and by people lacking in experience and knowledge if they are appropriately supervised or given suitable instructi-ons on the safe use of the device and understand the dangers its use entails. Children should not be allowed to play with the device. Children should not clean or do maintenance on the device without supervision.

Consult your physician before using this product if:

• You are pregnant
• You have a pacemaker, an implant, or other aids
• You suffer from diabetes
• You have a circulatory disorder
• You have concerns about your health

The elderly and infirm should consult their doctor before using the product, even if there are no specific pre-existing conditions. Because skin friction can be painful, it is recommended that the device not be directly applied to the skin. Stop using it immediately if you feel discomfort or pain. Do not use this product at bedtime. The massager has a stimulating effect and can delay sleep. To avoid a short circuit, connect the device correctly and keep it away from metal (needles), waste, and water. Use the device on a flat surface, if the device is not stable, it could tip over and cause injury. remove the adapter from the power outlet when not in use. If you suspect a problem, turn off the device as soon as possible. When not in use for extended periods store the device in its packing in a safe, dry cool place.

Do not place any other objects on the massager. If the power cord is damaged, it must be replaced, but only by an authorized and qualified person. To reduce the risk of electric shock, do not use the device on wet skin. Keep the product away from moisture. Do not use the product if it or its parts are wet or damp. This device may be used by children aged eight and over, by people with reduced physical, sensory, or mental abilities, and by people lacking in experience and knowledge if they are appropriately supervised and given suitable instructions on the safe use of the device and understand the dangers its use entails. Children should not be allowed to play with the device. Children should not be responsible for cleaning or maintaining the device unless they are over the age of eight and supervised by an adult. Keep the device and its cable out of the reach of children under the age of eight and of pets and animals.

To avoid injury and irreparable damage always sit while using the massager. To avoid dangerous injury, never stand on the unit or use it forcefully. Do not attempt to disassemble or repair the product. Repairs may only be carried out by suitably qualified technicians.

PRODUCT DESCRIPTION

Control Panel

1. VIBROPULSE PRO main unit

2. Shiatsu massage rollers

3. Foot pads

4. Power plug

5. Power adapter

6. Control power

7. Display area

8. ON/OFF button

9. Programming button (Programme)  P

10. Start button

11. Stop button

12. Button + Time/Speed increase button  +

13. Button -Time/Speed decrease button  –
    REMOTE CONTROL

14. Remote Control

15. Button + Speed increase button

16. Button + time increase button

17. Program button  P

18. Button – time decrease button

19. Button + Speed decrease button

20. Start and stop button

21. ON/OFF button

THE SET CONTAINS

1. VIBROPULS PRO main unit
2. Remote control
3. Instruction manual in 4 languages
4. Power adaptor

INSTRUCTIONS FOR USE

• Operating features
• Speeds from 1 to 20
• Ten specifically designed programs

Note
The device is designed to be used on the sole of the foot, the legs, and the back. Do not use it on the waist, neck, or other parts of the body not described in this manual. Do not use the device for purposes other than those specified in this manual and the exercise guide

1. Place unit (1) on a flat-level surface

2. Plug one end of the adapter (5) into the mains and the other into the power jack (4)

3. The functions of the VIBRAPULS PRO can be selected on the control panel on the device or on the remote control (14), as described below. The remote control runs on 2 CR203 batteries (included). Insert them into the battery compartment by following the polarity marks.

4. To turn the device on and off, press the ON/OFF button (8)

5. When the device is on, press the “P” button (17) on the remote control to choose one of the 8 VIBRAPULS PRO automatic programs (P1, P2, P3, P4, P5, P6, P7, P8). Press the “Programme” button (17) on the remote control to choose one of the 2 manual programs (H0 and H1). To choose the program on the device, just press the program button (P) on the device (7). Press this button to switch from automatic to manual programs. The chosen setting is shown on the display panels (7).

6. See program table
   AUTOMATIC PROGRAMMES
   P1 –

   • Vibrate only: Range of intensity levels 6 – 15
   • Time: 10 minutes
     P2 –
     Vibration and vibration + massage
   1. minute —— vibration
   2. minutes —– vibration + massage
   3. minutes —— vibration
   4. minutes —– vibration + massage
   5. minutes —— vibration
   6. minutes —– vibration + massage
   7. minutes —— vibration
   8. minutes —– vibration + massage
   9. minutes —— vibration
   10. minutes —– vibration + massage
   11. Range of intensity levels: 9 – 15
   12. Time: 10 minutes
       P3 –
       Vibration only

   • Range of intensity levels: 9 – 15

   • Time: 10 minutes
     P4 –
     Vibration and vibration + massage

   • 2 minutes—— vibration

   • 2 minutes —– vibration + massage

   • 3 minutes —– vibration

   • 3 minutes —– vibration + massage

   • Range of intensity levels: 9 – 15

   • Time: 10 minutes
     P5 –
     Vibration only

   • Range of intensity levels: 12 – 19

   • Time: 10 minutes
     P6 –
     Vibration + massage

   • Range of intensity levels: 12 – 15

   • Time: 10 minutes
     P7 –
     Vibration and vibration + massage

   • 2 minutes—— vibration

   • 2 minutes —– vibration + massage

   • 3 minutes —– vibration

   • 3 minutes —– vibration + massage

   • Range of intensity levels: 12 – 18

   • Time: 10 minutes
     P8 –
     Vibration + massage

   • Range of intensity levels: 12 – 18

   • Time: 10 minutes
     MANUAL PROGRAMMES
     H0
     Manual programs, vibration only

   • Range of intensity levels: 1 – 20

   • Time: 10 minutes
     H1
     Manual programs, vibration + massage
     

   • Range of intensity levels: 1 – 20

   • Time: 10 minutes

7. To start and stop the chosen program press the Start/Stop button (20)

8. It is not possible to set the time of speed on automatic programs

9. If you choose one of the two manual programs (H0 and H1), you can set a time of 1 up to 10 minutes before starting the program.

   • Press the More Time button (T+) (16) on the remote control or the 0 buttons on the unit (12) to increase the time
   • Press the Less Time button (T-) (18) on the remote control or the 0 buttons on the unit (13) to lower the time.

10. Once you have chosen the time, press the Start/Stop button (20) on the remote control or the Start button (10) on the device. To start the program when the program begins, you can set the speed from 1 to 15 at any time.

    • Press the More Speed button (S+) (15) to increase the speed
    • Press the Less Speed button (S-) (19) to reduce the speed

11. To turn of the device, first press the Start/Stop button (20) on the remote control or the stop button on the device (11). Then press the ON/OFF button on the device (21) to turn it completely off.

12. Disconnect the device from the mains after use.

CLEANING

Always unplug the device from the mains before cleaning it. Wipe the device and foot pads (4) with a damp cloth and mild soap. Do not use abrasive or corrosive cleaners. The food pads can be removed for easy cleaning (4).

TECHNICAL SPECIFICATIONS

• Input: 24V
• Power: 30W
• Adapter Technical Specifications
• Input: 100 – 240 V

WARRANTY

This product is covered by a warranty against manufacturing defects subject to the time periods stipulated by the legislation in force in each country.

22C97/22000
H.A.C BV
1183AT 7 Amstelveen The Netherlands www.hollandasia.com.

References

• H.A.C. BV – Holland Asia Connection

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>