VICOUSTIC VicPattern Ultra Wavewood panel Instruction Manual
- June 9, 2024
- VICOUSTIC
Table of Contents
VICOUSTIC VicPattern Ultra Wavewood panel
MATERIAL NEEDED
INSTALLATION
This product can also be installed on the ceiling and wall with the VicFix J Profile 2m (sold separately). For corner installation, use the VicFix Corner (sold separately).
- The Wavewood pattern is merely indicative. This method applies to any products in the VicPattern Ultra range.
Please note: For ceiling installation do not use the VicFix J Profile sections supplied with the product. Use the VicFix J Profile 2m, sold separately. It is recommend to leave some centimeters beyond the last panel to avoid it to loose contact with the VicFix J profile. In countries where earthquakes are likely to happen, it should be applied a blocking element such as a L profile to avoid the last panel to slide off the VicFix J profile. Vicoustic will not take responsibility for any mistakes/ limitations occurring during installations or any damages resulting from falling panels.
Ways of using the gauge
Step by step wall installation
Main Office, R&D & Logistics
Avenida do Pólo 3, Nº 159, Carvalhosa
4590-137 Paços de Ferreira, Portugal
T (+351) 255 136 746
Office
Rua Quinta do Bom Retiro Nº 16, Armazém 9
2820-690 Charneca da Caparica, Portugal
T (+351) 212 964 100
Info and Sales
E sales@vicoustic.com
www.vicoustic.com
© Vicoustic, 2019 | V2
No parts of this document might be copied and/or published without written
consent of Vicoustic.