HELIOS TECHNOLOGIES PTUV-02 Bluetooth Speaker User Manual
- June 9, 2024
- HELIOS TECHNOLOGIES
Table of Contents
HELIOS TECHNOLOGIES PTUV-02 Bluetooth Speaker
Brief introduction
This system is a music player office chair with a wireless Bluetooth connectivity function.
- With Bluetooth music module, in order to connect smoothly within maximum of 10 meters straight line.
- Stereo SW X 2 channel amplifier high-fidelity audio output.Support for subwoofer output
- Support audio input and headphone function
Structure Description
The system consists of left and right channels of high-quality speakers, a main control box, a charger, a motor, Audio line.
Instructions
- STEP 1: Plug the adapter output into the ‘DC PORT’and plug the adapter into the home outlet.
- STEP 2: Turn the unit ON. When the green light flashes and you hear the prompt tone, the Bluetooth pairing mode is turned on. Turn on your phone’s Bluetooth and find the following device name “gaming chair” and connect. (Note: It is only connectable to one device at one time.) When the Bluetooth device is not connected, please restart the power.
- STEP 3: The AUX port can transmit audio to the speaker for playback. The aux port can be connected to the mobile phone. Just prepare an audio cable and plug the plug into the phone’s earphone jack and the aux port to connect. The cushions can vibrate according to the audio, and when the sound stops, the vibration also stops.
- STEP 4: It can adjust the volume and the vibration intensity. It also can connect headphones.
The Main Parameters
- Input rating: DC 12V 1.2A
- Stand-by current: s1OmA
- Temperature Range: -200C to +70oC
- Wireless transmission range: 10 meters
- Sensitivity: -80dBm<+/-0.1%BER
- Frequency range: 2.4GHz-2.480GHz
- Audio Performance: Support AAC, MP3, SBC, Stereo
- Audio signal-to-noise ratio: 275dB
- Distortion: <0.1%
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
IC Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
The device has been evaluated to meet general RF exposure requirements. The devicecan be used in portable exposure conditions without restriction.