VANGUARD VG286-3 Renault Master x3 ULTI Van Roof Bars Instruction Manual
- June 4, 2024
- Vanguard
Table of Contents
Fitting Instructions – Read instructions carefully before fitting and follow
them for correct use
IN8100
ULTI Bars – X3
Tested to 80kg per bar. The maximum load is in accordance with the vehicle manufacturer’s load-bearing capacity (refer to the vehicle handbook). Do not exceed this limit.
This FITTING INSTRUCTION is the property of VANGUARD ACCESSORIES LTD. and must
not be used for manufacturing purposes, copied nor communicated in any way to
third parties without written permission from VANGUARD ACCESSORIES LTD.
IN8100_F (CN:00114)
THIS PRODUCT SUITS THE FOLLOWING VEHICLES
VG286-3
Vehicle:
Nissan NV400: 2010-2021
Nissan Interstar: 2022 on
Renault Master: 2010 on
Vauxhall Movano: 2010-2021
Wheel Base: SWB (L1)
Roof Height: Low (H1)
Rear Doors: Twin
Remove roof plugs to reveal the vehicle fixing points.
Stick rubber pads to all roof brackets.
Loosely secure the middle inner fixing brackets to the inside of the vehicle by inserting the M6 1/4 turn nut inserts (FX4025) into the positions shown in FIG.1. Then place the middle inner bracket into place and loosely bolt into the M6 1/4 turn inserts using M6x20 hex bolts and M6 washers. Please note the cable trim (shown in FIG.2) may have to be removed. This trim can be refitted after the inner bracket has been secured.
Loosely secure the rear inner fixing brackets to the inside of the vehicle by inserting the M6 1/4 turn nut inserts (FX4025) into the positions shown below. Then place the rear inner bracket in position and loosely bolt into the M6 1/4 turn inserts using M6x20 hex bolts and M6 washers.
Place the roof brackets onto the roof and bolt down through the fixing points and through the inner fixing brackets using M8X40 hex bolts, M8 washers & rubber washers.
Place the roof bars onto the roof brackets and loosely secure them using M6X16 coach bolts & M6 flange nuts.
Adjust the roof bars to ensure that they are evenly spaced on the vehicle.
Tighten the roof bar fixings to 8Nm.
Secure the roof brackets to the inner fixing brackets using M8 flange nuts and tighten to 12Nm.
Tighten the M6 fixings on all inner fixing brackets to 8Nm.
-
Regularly inspect all fixings and parts. Any damaged or worn parts should be immediately removed from the vehicle and replaced.
-
Take care when loading and unloading goods onto and off the roof of the vehicle.
-
Van Guard Accessories LTD and/ or its distributors do not accept liability for:
-Any products that have been fitted incorrectly.
– Any products which have been fitted to the incorrect vehicle.
– Any products that have been modified in any way or are being used for any purpose that they are unintended for. -
It is important that the end user receives this document and that instructions are retained for future use.
IN8100 – PAGE 8 OF 8
Documents / Resources
|
VANGUARD VG286-3 Renault Master x3 ULTI Van Roof
Bars
[pdf] Instruction Manual
VG286-3, Renault Master x3 ULTI Van Roof Bars, VG286-3 Renault Master x3 ULTI
Van Roof Bars
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>