SURVIVE-A-STORM XPANEL0604 Extreme Storm Shelters Instruction Manual
- June 9, 2024
- SURVIVE-A-STORM
Table of Contents
SURVIVE-A-STORM XPANEL0604 Extreme Storm Shelters
Assembly Hardware Included
| 4×4| 4xli| 4×8| 6×4| 6×6| 6×8| 8×4|
8×6| 8×8
---|---|---|---|---|---|---|---|---|---
l¼” Ban| B4.| 108| 132| 106| 132| 158| 132| 158|
184
¾” Anchor
| 16| 20| 24| 20| 24| 28| 24| 28| 32
¼” Washer| 156| 196| 240| 192| 240| 288| 240| 288|
336
¼” Nut
| 68| 88| 108| 86| 108| 130| 108| 130| 152
½·cage Nut| 16| 20| 24| 20| 24| 28| 24| 28|
32
Tools Needed
Hammer
utility Knife
¾” Socket & Ratchet
Torque Wrench
¾” Wrench
¾” Masonry Brt
Hammer ‘Drill
-
Start with any B corner by placing it in your desired location.
-
Attach adjacent A panel to B corner using the 1 ½” bolts with a washer on both the bolt and nut sides. Do not tighten, yet.
-
Proceed with remaining panels until finished as shown in diagram. Add or subtract 2’ A panels to create size of building purchased. If you have A/V (audio/video) panels, they can be substituted in any of the A panel locations.
-
Install the roof J panels. The roof’s square holes will have cage nuts on the outside. Use 1 ½” bolts
and washers from the inside. Do not tighten. -
Straighten and square walls. Using ¾” socket and wrench, tighten and torque bolts as you square up. Tighten and torque roof.
-
Using a 3/8” masonry bit, drill 4” deep holes at the anchor hole locations. Tap in wedge anchors in holes. Put washer and nut on anchor and tighten to manufacturer recommended 25 lbs. torque.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>