eufy T8502 Security Smart Lock User Guide
- June 9, 2024
- Eufy
Table of Contents
eufy Security Smart Lock E110
Model: T8502
51005003597 V02
QUICK START GUIDE
AT A GLANCE
-
Keypad
-
Status Light
• Blue: Door unlocked
• Orange: Door locked
• Red: Abnormal -
Keyway
-
USB-C Port: Charges the lock in emergency situations.
- Battery Compartment
- Serial Number: Use to add the lock to the eufy Security app.
- QR Code: Use to add the lock to the eufy Security app.
- SYNC Button: Use to pair the lock with the doorbell chime.
- Thumbturn
- Screw Hole
WHAT’S INCLUDED
For Smart Lock Installation
INSTALLATION
Step 1. Prepare the Door
- Remove the existing lock and check your door.
- Check if your door has holes like the one below. Standard US doors are already compatible.
• If not, follow the template to drill holes on your door.
Step 2. Install Deadbolt
- Check your door to see if the deadbolt requires adjustment.
- Insert and screw the deadbolt into the doorframe.
Step 3. Install Exterior Assembly
- Remove the spacer before installation if you have a 38 mm cross bore.
Step 4. Install Interior Assembly
-
Detach the back cover from the interior assembly.
-
Run the wires through the back cover.
-
Secure the back cover with screws.
Tightly fasten the screws in place. Set the screws with your hands, then use a screwdriver to secure them.
• (Optional) If the back cover is not fastened
tightly to the door, use the additional screw provided.
-
Wire to the interior assembly.
-
Mount the interior assembly. Make sure both wires are tucked into the cabin on the back of the interior assembly.
-
Install the 4 AA batteries provided with the correct polarity. Don’t put on the cover until the system setup is done in the app.
Step 5. Install Strike Plate
Make sure the depth of the latch hole on door frame is deep enough
(25.4mm/1”), otherwise the calibration might be failed during the setup.
SETTING UP THE SYSTEM
- Download and install the eufy Security app, then sign up for an account.
- Follow the in-app instructions to add the Smart Lock E110 to your device list.
• Please visit https://support.eufylife.com/s/ or scan the QR code for more information.
https://support.eufylife.com/s/
NOTICE
Warning
- replacement of a battery with an incorrect type that can defeat a safeguard;
- disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
- leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; and
- a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
Notice (United States Of America)
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: (1)
Reorient or relocate the receiving antenna. (2) Increase the separation
between the equipment and receiver. (3) Connect the equipment into an outlet
on a circuit different from that to which the receiver is connected. (4)
Consult the dealer or an experienced radio/ TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in fixed/mobile exposure condition. The min separation
distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables
to maintain compliance with FCC regulations.
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
Address: 10900 NE 8th St, Ste 501, Bellevue WA 98004
Telephone:1-800-988-7973
Notice (Australia)
Do not use the Device in the environment at too high or too low temperature,
never expose the Device under strong sunshine or too wet environment.
It is recommended to supply the device in an environment with a temperature
that ranges from 5°C~25°C.
When supplying, please place the device in an environment that has a normal
room temperature and good ventilation.
Warning:
- replacement of a battery with an incorrect type that can defeat a safeguard;
- disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
- leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; and
- a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE.DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.
This symbol means the product must not be discarded as household waste,
and should be delivered to an appropriate collection facility for recycling.
Proper disposal and recycling helps protect natural resources, human health
and the environment. For more information on disposal and recycling of this
product, contact your local municipality, disposal service, or the shop where
you bought this product.
Notice (Canada)
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1)this device may not cause interference, and (2)this device must accept any
interference, including interference that may cause undesired operation of the
device.
This Class B digital apparatus complies with Canadian ICES-003.
IC RF Statement:
When using the product, maintain a distance of 20cm from the body to ensure
compliance with RF exposure requirements.
Customer Service
12-month limited warranty
(US) +1 800-988-7973
(UK) +44 (0) 1604 936200
[email protected]
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
@EufyOfficial
@EufyOfficial
@EufyOfficial
Anker Innovations Limited. All rights reserved. eufy Security and eufy
Security Logo are trademarks of Anker Innovations Limited, registered in the
United States and other
countries. All other trademarks are the property of their respective owners.