PROCORE PLUS HBWD8776 6-Inch Wide x 6-mm Thick Waterproof Interlocking Luxury Vinyl Plank Flooring Instruction Manual
- June 9, 2024
- PROCORE PLUS
Table of Contents
PROCORE PLUS HBWD8776 6-Inch Wide x 6-mm Thick Waterproof Interlocking
Luxury Vinyl Plank Flooring Instruction Manual
PROCORE® PLUS HERRINGBONE MAINTENANCE INSTRUCTIONS
Precautions:
Remove all metal objects before conducting maintenance and prohibit foot
traffic until the floor is dry.
Do not use dust mops treated with oils or silicones, acetone, strong alkaline
cleaning agents, multi-surface cleaners, vinegar/ammonia/ citrus oil
solutions, scouring powder, strong solvents, or abrasive cleaning pads, as
these can damage the flooring.
The application of a floor finish is not usually recommended and will change
the maintenance protocol.
Regular Cleaning:
Dust-mop or vacuum the floor to remove any dirt or grit – do not use a vacuum
with a beater bar.
Damp-mop the floor as often as required using a flat microfiber mop or a flat
microfiber spray mop.
We recommend a pH neutral, film-free and streak free cleaner concentrate,
available at Lowe’s.
Make sure to change the pad as often as required. Steam cleaners with a micro-
fiber head may also be used, providing the steaming head is never stationary,
as prolonged, excessive heat can damage any vinyl floor covering.
Deep Cleaning:
Deep cleaning may be required when routine cleaning is not meeting
expectations.
Dust-mop or vacuum the floor to remove dirt or grit.
Wet mop the entire floor using a suitable neutral pH cleaning solution. Allow
the solution to dwell for ∼ 5-10 minutes.
Scrub the floor using a medium nylon broom or brush and remove the soiled
solution using a wet vacuum.
Rinse with clean water and allow it to dry before allowing foot traffic.
Protection:
If required, protect the clean floor covering from other trades or heavy loads
using ½-inch plywood or similar and tape all seams.
For light traffic, use Ram board or similar and tape all seams.
For furniture, use only polyurethane, silicon or felt glides (replaced >
3-times a year), keeping them clean and grit-free – all glides should be ≥
1-inch2, especially on heavy furniture.
Use protective chair mats designed for resilient flooring underneath rolling
chairs or soft “W-type” wheels.
Failure to observe these requirements could result in joint damage or failure.
Use non-rubber-backed entrance matting at all outdoor entrances, as this will
improve air quality and reduce maintenance.
Do not drag heavy or sharp objects directly across the surface – use hard
surface “sliders” (available at Lowe’s).
For areas that may be subjected to standing water on the surface, such as
bathrooms with a bath or shower, the perimeter of the installation must be
properly sealed using a 100% silicon caulk to prevent water from getting
beneath the flooring.
To avoid excessive fading or discoloration from direct sunlight exposure, use
appropriate window treatments, an effective UV/IR film or Low-E glass windows.
Take photographs and have any required documentation signed and filed
following completion.
CUSTOMER SUPPORT
Manufactured by Novalis Intl.
P: 888-509-3438
E: [email protected]
Web: procorefloors.com
Revised on: 11.2.21
Page 2
