MAMI SafeNode 32 Zone Wireless Alarm System Owner’s Manual
- June 9, 2024
- MAMI
Table of Contents
MAMI SafeNode 32 Zone Wireless Alarm System
Description
The Safe Node is a 32 zone wireless alarm system. It is made for quick and easy installation solve the needs of small houses our apartments. Simply mount the Safe Node connect the battery and power and you are ready to operate the easiest Alarm System ever.
The Safe Node communicates the following alarm signals.
On-board signals: Panic, Medical, Fire, Mains fail/restore, battery low]
All of the above signals can be communicated to the Mission Control Mobile App (Android and iOS) and/or a control room.
In addition to being its own self-contained alarm system, the Safe Node is
able to communicate any panic pressed in the area of a Safe Node. This allows
a network of Safe Nodes to be used to communicate a panic for anyone carrying
a Safe Node Remote.
Connecting the Safe Node : The safe node comes pre-wired with ac adaptor
and siren wire. Connect the internal battery and close the Safe Node
enclosure. Connect the AC adaptor to mains power
- Remove screw at bottom
- Lift SafeNode from bottom (hinge on top)
Safe Node G/5
Start up
The SafeNode will boot up with the RED led on and green flashing fast. Safe NodeS (Sigfox) – Successful Signal reception from Sig fox network is indicated by 4 beeps Safe NodeS (GSM) – Successful connection to mobile phone network will be indicated by the Green LED flashing slowly.
Adding wireless devices
Step2 : Open the SafeNode as described on page1
Step3 : Disconnect battery
Step4 : Whilst pressing the onboard PANIC button (top bottom) connect the
battery until continuous beeping is heard, release the button.
Step5 : Trigger the device to be added
Step6: Successful programming will be indicated by 1 beep
the Zone number is added sequencially
Removing all devices
Follow Step 1-3 above
Step4: Whilst holding the onboard PANIC and FIRE button connect the
battery until continuous beeping is heard. The device will boot up normally
with the wireless devices cleared.
Mission Control Mobile
Monitoring (APP)
To receive notification from the SafeNode on a mobile APP please follow these
steps.
Please scan the QR code to navigate to the download link for Android and Apple
iOS
Step1: Download register and sign in to MissionControl0
Step2: Click the “+” in the top right of the App once you have logged in
Step3: Enter in the IMEI of the~ ce, found barcode stick on the GiSMo
Step4: Enter 0000 as the Has
Step5: Click the “ADD DEVICE”
Your notifications will displayed under the “ALERTS” Section of the App
Operating
The Safe Node is equipped with a remote control to perform the following functions
Pressing Panic will trigger the siren output and the onboard buzzer will beep
for 2minutes, device to transmit Panic to cloud Silent Panic will make not
audible noise and transmit a Duress Panic to the cloud. Arm is indicated by a
single beep. 30 seconds is given as an exit delay. Disarm is indicated by 2
beeps
After any alarm or panic activation the siren and onboard buzzer can be
silenced by pressing the disarm button
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>