Sage JSG-M004 Telematics Control Unit User Manual
- June 9, 2024
- Sage
Table of Contents
Sage JSG-M004 Telematics Control Unit
General
Purpose of this Guide is to install the devices and to describe the related function how to use them for the Dealers and Mechanic of contracting company. The functions are necessary to operate the initial setup and maintain an appropriate usage of the App.
FCC Statement：
Any changes or modifications not expressly approved by three-party responsible
for compliance could void the User’s authority to operate the equipment.
This Device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This Device may not cause harmful
interference, and (2) this Device must accept any interference received,
including interference that may causeundesired operation.
FCC Radiation Exposure Statement:
This Device complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 8 inches (20cm) between the radiator & User’s
body.
This transmitter must not be co-located or operating IN conjunction with any
other antenna or transmitter.
Class B digital device:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
JSG-M004 data sheet
Physical
Size| W140×D50×H25 mm
Weight| 150g
Environment
Operating temperature| -20 degrees C to +60 degrees C
Storage temperature| -30 degrees C to +80 degrees C
Performance
Maximum electric power consumption| 200mA / 12V
Standby electric power consumption| 100mA / 12V
Version
Hardware version| 1.00
Software version| 1.00
System Block digram
Appearance
Components
- LPWA module (BG95M3)
- SIM socket
- Power connector
Connector Pin Assignment
Mating coupler information is
as follows: TCU side：6187- 4441
Wire harness side：6180-4181
| Pin No. | Assign |
|---|---|
| TCU | |
| 1 | N/A |
| 2 | GND |
| 3 | Vin |
| 4 | N/A |
Installation
The TCU should be installed safety place that can reach with the harness.
Recommend to install with the top surface of the housing facing the sky.
This product used at a distance 8 inches (20cm) or more from the User’s body.
Since this product is fixed to the construction machine with,
Double sided tape it is used with the human body at a distance of 8 inches or
more.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>