Oase 5000 AquaMax Eco Dual Intake Pumps Instruction Manual

: June 9, 2024
: Oase

Table of Contents

5000 AquaMax Eco Dual Intake Pumps
Safety information
Intended use
Installation and connection
Maintenance and cleaning
Malfunction remedy
Read User Manual Online (PDF format)
Download This Manual (PDF format)

AquaMax Eco
5000, 8000, 11000, 14000, 17000
Operating instructions

5000 AquaMax Eco Dual Intake Pumps

Oase 5000 AquaMax Eco Dual Intake Pumps - Figure 1 Original manual. This manual belongs with the unit and must always be passed on together with the unit.
WARNING

This unit can be used by children aged 8 and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they are supervised or have been instructed on how to use the unit in a safe way and they understand the hazards involved. Do not allow children to play with the unit. Only allow children to carry out cleaning and user maintenance under supervision.
Only operate the unit if no persons are in the water.

Safety information

Electrical connection

Special regulations apply for electrical installation in outdoor spaces. Only a qualified electrician may perform the electrical installation.
– The qualified electrician has the necessary professional training, knowledge and experience to perform electrical installation in outdoor spaces. The electrician can detect potential dangers and knows how to adhere to regional and national standards, regulations and directives.
– For your own safety, please consult a qualified electrician.
Only connect the unit if the electrical data of the unit and the power supply match.
Only plug the unit into a correctly installed outlet. Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current protection device.
Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use (splash-proof).
Protect open plugs and sockets from moisture.

Safe operation

Do not use the unit, if electrical lines or the housing are damaged.
Dispose of the unit if its power connection cable is damaged. The power connection cable cannot be replaced.
The impeller unit in the pump contains a magnet with a strong magnetic field that may affect the operation of pacemakers or implantable cardioverter defibrillators (ICDs). Keep a distance of at least 0.2 m between the implant and the magnet.
Do not carry or pull the unit by its power cable.
Route lines in such a way that they are protected from damage and do not present a tripping hazard.
Never carry out technical changes to the unit.
Only carry out work on the unit that is described in this manual.
Only use original spare parts and accessories.
Should problems occur, please contact the authorised customer service or OASE.

Intended use

Only use the product described in this manual as follows:

For pumping normal pond water for water features and fountains.
While adhering to the technical specifications.
Use for private purposes only.

The following restrictions apply to the unit:

Do not use in swimming ponds.
Never use the unit with fluids other than water.
Never run the unit without water.
Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Do not connect to the domestic water supply.

Installation and connection

Connecting the hose
How to proceed:
 A

Screw the stepped hose adapter to the outlet.
Shorten the stepped hose adapter to the diameter of the hose used if necessary.
– This reduces pressure losses.
Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.

Installing the unit
 B

Never operate the pump in a swimming pond.
Ensure that the connection to the power supply is at least 2 m from the pond.
Place the unit horizontally on a firm, mud-free ground.

Commissioning/start-up
NOTE
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical components.
• Do not connect the unit to a dimmable power supply.
Switching on: Connect the unit to the mains. The unit switches on immediately.
Switching off: Disconnect the unit from the mains.

Maintenance and cleaning

Cleaning the device
Recommendation regarding cleaning:

Clean the unit as required but at least twice a year.
When cleaning the pump, pay particular attention to the cleaning of the impeller unit and pump housing.
In the event of the filter housing capacity reducing, clean the unit under running water using a brush.
Do not not use cleaning agents or chemical solutions.
Recommended cleaning agent for removing stubborn limescale deposits:
– Pump cleaning agent Pompeian from OASE.
– Vinegar- and chlorine-free household cleaning agent.
After cleaning, thoroughly rinse all parts in clean water.

Cleaning/replacing the impeller unit
How to proceed:
 C

Remove screws.
– The screws are used as transport protection and not required for operation.
Actuate the engagement hook and fold up the strainer top casing.
Remove pump.
Remove screws.
Remove the pump housing including its holding ring, sealing and impeller unit.
– Clean all components under running water using a soft brush, replace damage parts.
Reassemble the unit in the reverse order.
– Place the pump cable into the cable opening of the bottom strainer casing such that the cable will not be crushed when closing the filter housing.

Storage/winter protection
The unit is not frost-proof and has to be removed and put into storage if minus temperatures are expected.
How to correctly store the unit:

Thoroughly clean the unit and renew any damaged parts.
Protect electrical connections from moisture and dirt.
Store the pump submerged and in a frost-free environment.
Protect open plug connections from moisture and dirt.

Malfunction remedy

Malfunction	Cause	Remedy
Pump does not start	No mains voltage	Check mains voltage

Clean/check supply lines
Pump does not deliver| Filter housing clogged| Clean strainer casings
Reduce hose length to the necessary minimum, do not use unnecessary connection parts
Insufficient delivered quantity| Filter housing clogged
Excessive loss in the supply hoses| Clean strainer casings
Reduce hose length to the necessary minimum, do not use unnecessary connection parts
Pump switches off after a short running time| Excessively soiled water
Water temperature too high| Clean pump
Note maximum water temperature of +35 °C

Wear parts
• Impeller unit
Disposal
NOTE
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system provided for this purpose.

| Type| Weight| Rated voltage| Power consumption| Max. flow rate| Max. head
height| Connection to
the pump inlet| Connection to the pump outlet| Cable length| Water temperature
---|---|---|---|---|---|---|---|---|---|---
AquaMax
Eco| 5000| 3.4 kg| AC 220-240 V, 50 Hz| 60 W| ≤ 5000 l/h| ≤ 2,6 m| G1½| G1½| 10 m| +4 … +35 ºC
8000| 4.4 kg| 70 W| ≤ 8000 l/h| ≤ 2,8 m
11000| 95 W| ≤ 10000 l/h| ≤ 3,0 m
14000| 5.4 kg| 140 W| ≤ 13400 l/h| ≤ 3,2 m
17000| 180 W| ≤ 17000 l/h| ≤ 3,5 m
| | | | |
---|---|---|---|---|---
Dust tight. Submersible to
4 m depth.| Remove the unit at temperatures below zero
(centigrade).| Possible hazard for persons wearing pace makers!| Protect from direct sun radiation.| Do not dispose of together with household waste!| Attention!
Read the operating instructions
Recommended water quality| pH value| Total hardness| Temperature
---|---|---|---
| 6.8 … 8.5| 8 … 15 °dH| 4 … 35 °C
| AquaMax Eco
---|---
Pos.| 5000| 8000| 11000| 14000| 17000
1| T 18008| 18008| 18008| 18008| 18008
2| 18006| 21729| 21729| 21554| 21554
3| 18014| 18015| 21544| 21551| 31113
4| 11825| –| –| –| –
5| –| 11824| 21552| 21553| 311128
6| 18010| 18010| 18010| 18010| 18010
7| 17581| 17581| 17581| 17581| 17581