ETERNICO AET-MS330SB Wireless Mouse User Manual

AET-MS330SB Wireless Mouse
User Manual

AET-MS330SB Wireless Mouse

THANK YOU FOR CHOOSING US!
We value your trust. We hope that you will be happy with our product, and as excited about it as we are. We try to offer products of the highest quality that satisfy even the most demanding requirements. If you are satisfied, it would make us very happy if you chose us again the next time you make a purchase.
We are environmentally conscious, therefore we use special eco -friendly packaging. Please recycle!
Recycling and Environmental Protection
We try to avoid using plastic packaging and film and only use them when they are absolutely necessary to protect the product. So how are we different?
Packaging you can eat… Well, almost. 🙂
We use ink made from soybeans as opposed to classic petroleum -based ink.
The majority of our packaging is made from 100% recyclable paper.
We limit the use of adhesives. If absolutely necessary, we make sure to choose only water -soluble ones.
We think globally, which means that we actively search for eco -friendly solutions. We keep an eye on trending technology and place findings of the scientific community into practice.
We don’t just try to meet quotas and mandates, we aim to exceed them.

TECHNICAL PARAMETERS

OVERVIEW

1. Left mouse button
2. Centre wheel
3. Side buttons forward / backward
4. DPI button (sensor resolution setting)
5. Low battery LED indicator
6. Right mouse button
7. Button for switching operating modes
8. Battery compartment cover
9. Optical sensor
10. ON/OFF switch

INSTRUCTIONS

Inserting and replacing the battery
You must insert a battery to control the mouse. Proceed as follows:

1. Turn the mouse upside down, gently push the battery cover, and slide it outward.
2. Insert a new AA alkaline battery. Observe correct polarity when inserting the battery; it is marked on the bottom of the battery compartment.
3. Replace the cover and slide it toward the center of the mouse. The correct placement of the cover is signalled by a snap.

When you replace the battery proceed in the same way, except remove the spent battery. The low battery LED indicator will start flashing when the battery is discharged and it needs to be replaced.
Turning mouse On/Off
Turn the power switch on the bottom of the mouse to the “ON” position to turn on the mouse.
The LED indicator turns on. The default operating mode is 2.4 G.
When you are not using the mouse, set the power switch at the bottom of the mouse to the “OFF” position. This will prevent the battery from discharging prematurely.
If you will not be using the mouse for an extended period of time, turn the power switch on the bottom of the mouse to the “OFF” position and remove the battery. This will protect the mouse from damage if the battery electrolyte leaks.
Operating mode selection
The wireless mouse allows you to set the operating modes to 2.4 G, Bluetooth 1 or Bluetooth 2. To select an operating mode, press the operating mode selection button at the bottom of the mouse repeatedly in the following order: (operating mode 2.4 G) – BT1 (Bluetooth 1) – BT2 (Bluetooth 2). The default operating mode is 2.4 G.

2.4 G operating mode selection
Installation
The USB receiver is located in the space next to the battery. Turn the mouse upside down, gently push the battery cover, and slide it outward. Remove the USB receiver from the inside of the mouse and insert it into the USB-A port of your computer.
The mouse is installed automatically so you can control the mouse quickly and comfortably.
Bluetooth operating mode selection

1. Press the operating mode selection button repeatedly to select the BT1 (Bluetooth 1) or BT2 (Bluetooth 2) mode. The LED indicator of the selected mode lights up.
2. Press and hold the operating mode selection button for more than 3 seconds to enter the pairing process. The LED indicator of the selected mode will flash. The pairing time is 3 minutes.
3. On your computer, click “Add Device – Bluetooth” to start the device search.
4. Regardless of the Bluetooth 1/Bluetooth 2 operating mode selection, the device name will appear as MS330 BT3.0 and MS330 BT5.0.
5. If the pairing was successful, the LED indicator of the selected operating mode will go out after approx. 2 seconds and the mouse cursor will appear on the display.

CLEANING

Keep the wireless mouse clean. Turn the switch to the “OFF” position before cleaning.
Use only a dry, clean cloth for cleaning. Do not use harsh cleaners, solvents, gasoline or other similar substances. Never wash the wireless mouse with water and do not immerse it in water.
If you will not be using the wireless mouse for an extended period of time, set the power switch to “OFF” and remove the battery.

SAFETY INFORMATION

• Read the safety and operating instructions. Failure to observe the safety and operating instructions can endanger people or damage the device. And it may void your warranty.
• This product is only suitable for household use.
• This product is not a toy. It may contain small components. Please keep away from children.
• Do not use or leave the product in a dusty or otherwise polluted environment.
• Do not leave the product in high or low ambient temperatures. Keep the product in a dry environment.
• Keep this product away from heat sources such as stoves or direct sunlight. No naked flame sources, such as lighted candles, should be placed on the product.
• Do not expose the product to dripping or splashing water or other liquids. Do not place containers filled with water, such as vases, on the product.
• Do not touch the product with wet hands.
• This product is not considered a light fixture. Make sure that continuous operation does not exceed six hours.
• Never look into the light for a long time. There is a risk of serious eye damage.
• Do not disassemble the product. Attempting to modify the power bank may damage the product and result in a serious injury.
• Do not immerse the product in water or other liquids or throw it into a fire.
• Do not leave the product unattended while it is in operation.
• Avoid turning the product on and off frequently and repeatedly.
• While the product is in operation, it may become hot. This is a normal occurrence. Therefore, make sure that there are no heat-sensitive objects/surfaces near the product.
• If you notice an unpleasant odor or smoke while using the product, unplug the product immediately and stop using it. Contact an authorized customer center.
• Avoid overloading the product. Avoid dropping the product.
• Do not place any objects on the product. There is a risk of irreversible damage to the product.
• This product does not contain parts repairable by the user . In the event of a malfunction or defect contact the nearest authorized service center. Check it regularly for damage.
• Use only a soft, clean, dry cloth to clean the surface.
• Do not use any chemical cleaners, abrasives, gasoline, thinners or other similar substances. Before cleaning, make sure that the product is disconnected from the power supply.
• Store the product in a dry and well-ventilated place. Do not place any objects on the product when in storage.

DISPOSAL OF USED BATTERIES
**** Batteries contain materials harmful to the environment. Do not dispose of batteries in a regular community waste. Dispose of used batteries properly at collection points.

WARRANTY & SUPPORT

Your new product is protected by our 24-month warranty, or extended warranty (if stated), which you can apply at any of our points of sale. For inquiries, you can use the contact form or one of our international call centres.
United Kingdom: +44 (0)203 514 4411
On-line: www.alzashop.com/contact

This product meets all of the related basic EU regulation requirements. The EU declaration of conformity is available on www.alzashop.com/DoC.
This product sold in the European Union meet the requirements of Directive 2011/65/EU on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS).
The use of the WEEE Symbol indicates that this product should not be treated as household waste. By ensuring this product is disposed of correctly, you will help protect the environment. For more detailed information about the recycling of this product, please contact your local authority, your household waste disposal service provider, or the shop where you purchased the item.
“For indoor use only” symbol indicates that the product is not intended for outdoor use.

www.eternico.net
Co. Reg. No. 27082440
Alza.cz a.s., Jankovcova 1522/53, 170 00 Prague 7, Czech Republic
© 2022 Alza.cz a.s. All Rights Reserved.

References

• Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
• Alza.cz

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>