JBJ Accela Pro Wireless Smart Return Pump User Manual
- June 9, 2024
- JBJ
Table of Contents
JBJ Accela Pro Wireless Smart Return Pump
IMPORTANT SAFETY INSTRUCTIONS
WARNING
To guard against injury, basic safety precautions should be observed,
including the following:
READ ALL SAFETY INSTRUCTIONS BEFORE USE.
DANGER
To avoid possible electric shock, special care should be taken since water is
employed in the use of aquarium equipment. For each of the following
situations, do not attempt to repair your-self: return the appliance to an
authorized service facility for ser-vice or discard the appliance.
- A. If the appliance falls into water, DON’T reach for it! First un-plug it and then retrieve it. If the electrical components of the appliance get wet, unplug the appliance immediately.
- B. Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not intended to be wet.
- C. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it is dropped or damaged in any manner.
- D. To avoid the possibility of the appliance plug or receptacle getting wet, position aquarium stand and tank to one side of a wall mounted receptacle to prevent water from dripping onto the receptacle or plug. A “drip loop”, shown in the Figure at the right should be arranged by the user for each cord connecting an aquarium appliance to a receptacle. The ”drip loop” is that part of the cord below the level of the receptacle or the con- Drip Loop nectar if an extension cord is used, to prevent water travel along the cord and coming in contact with the receptacle.
If the plug or the receptacle do get wet, DON’T unplug the cord. Disconnect the fuse to the circuit breaker that supplies power to the appliance. Then unplug and examine for the pres-ence of water in the receptacle.
- E. Close supervision is necessary when any appliance is used by or near children.
- F. To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors, lamp bulbs, and etc.
- G. Always unplug an appliance from the outlet when not in use, before putting on or taking off parts, and before cleaning. Never yank the cord to pull plug from the outlet. Grasp the plug and pull to disconnect
- H. Do not use an appliance for other than intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.
- I. Do not install or store the appliance where it will be exposed to the weather or to temperatures below freezing.
- J. Make sure an appliance mounted on a tank is securely in-stalled before operating it.
- K. Read and observe all the important notices on the appliance.
- L. This Appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized out-let only one way. If the plug does not fit fully in the outlet, re-verse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not attempt to defeat this safety feature.
- M. This appliance is intended FOR HOUSEHOLD USE ONLY. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than the appliance rating may overheat. Care should be taken to ar- range the cord so that it will not be tripped over or pulled.
- O. Do not let the pump run dry.
CLEANING
It is important to keep this appliance clean. Always unplug
the appliance before performing maintenance or cleaning of the exterior of
this hood. Wipe exposed surfaces carefully
with a damp terrycloth to remove any dust or mineral depos-its which may
collect over time. Make sure all surfaces are dry before re-plugging into an
electrical outlet. To prevent scratching the aquarium, use a damp terrycloth
when clean-ing. Never use algae scrapers, scouring pads, razor blades, glass
cleaner or other such abrasives.
SERVICING
In order to assure proper electrical connections and polarity, replacement
parts and servicing should be performed only by a qualified electrician.
OPERATION
Please carefully read the entire “Owner’s Manual” for proper operation
procedures before proceeding with turning on this appliance and adding
livestock such as fish, corals, and inverte-brates.
SAVE THESE INSTRUCTIONS
PARTS VIEW MT-604-LED
| # | DESCRIPTION |
|---|---|
| 1 | WIFI CONTROLLER |
| 2 | POWER SUPPLY |
| 3 | PUMP MOTOR |
| 4 | PUMP HEAD |
| 5 | PUMP GUARD |
| 6 | IMPELLER ORING |
| 7 | IMPELLER ASSEMBLY |
| 8 | PUMP BASE |
SMART SUBMERSIBLE PUMP
The Accela Pro is a smart submersible pump that can be con-figured to your
unique aquarium. It’s compact form factor makes it easy to fit into most all-
in-one aquariums. The hybrid impeller design and ceramic drive shaft quietly
and efficiently cycle water through your filtration system.
Our network allows you to run the Accela Pro on a schedule, and remotely
monitor and adjust your aquarium instantly.
HOME
Conveniently vie and manage all your devices. Quick Control options allow you
to adjust grouped Accela Pumps at the same time.
FLOW CONTROL
Customize your flow by programming your flow rate. Simply choose your time
settings and adjust the flow.
FEED MODE
Stop your flow when its feeding time to assure your feeding is not wasted.
Feeding mode will stop the flow rate for 10 mins during feeding time.
Model Dims Flow Rate Max Head
DCB-1500 4.5×2.3×3.3 396 5.5 ft
DCB-2500 5.4×2.9×4.2 660 8.2 ft
WHAT’S INCLUDED INSIDE OF BOX
Carefully unpack your new Accela PRO. Inspect all its components and confirm
all parts are included before using.
Report any damages or missing components to:
Toll Free—877-374-9981
Email—[email protected]
GETTING STARTED
Slide base plate onto pump
Attach slip fitting or barb fitting to pump
Attach hose/pipe onto barb/slip fitting.
- NOTE: PVC Pipe—use PVC cement/glue to securely attach pipe onto slip fitting.
- NOTE; Recommended to use a zip tie to securely attach hose onto barbed fitting
TURNING ON YOUR LIGHTING SYSTEM
Plug in the Power Supply to the WIFI Controller Plug in the WIFI Controller to
the Pump
Plug Power Supply into approved household outlet.
PUMP CONTROLLER
- Power On/Off Button
- Flow Rate Control
- Feed Button/Wave Mode
- WIFI /Reset Button
MANUAL CONTROLS USING THE CONTROLLER
Press Power button to turn on Accela Pro Pump
FLOW RATE
Control your flow by pressing the UP/DOWN buttons. Set the percentage of flow
from 0% to 100%
FEED BUTTON/WAVE FUNCTION
Press Once to set to Wave Function/Pulse Function.
Press Flow Rate button UP/DOWN to adjust the frequency of the Pulse. You can
adjust frequency 1 second to 2 seconds. This will allow the pump to set to
automatically pulse.
Press Twice to set to Feed Mode
This stops the flow rate 10 mins during your feeding period.
DOWNLOAD JBJ CONNECT APP
Download the JBJ CONNECT APP /JBJ INTELLIGENCE APP
Open APP and register your device.
CONNECT TO PUMP
Open APP and get onto Home Screen.
- Press (+) on top right corner to add Light.
CONNECT TO PUMP
Reset Controller by pressing the reset button. You will see a rapidly flashing
LED light.
Choose the WIFI you want to connect through and enter your password.
Note: Make sure your WIFI signal is at 2.4 GHz.
You are now connected to your Accela Pro pump
CONTROLLING PUMP WITH WIFI APP
Once you have connected you will be taken to Pump home screen. From here you
will see the different modes you can operate your pump.
- Manual Mode
- Custom Modes 1 & 2
- Feeding Mode
Manual Mode
This is the default mode of operation of the pump. Slide the “Flow Rate”
toggle to select the desired pump flow. You adjust from 0% to 100%
Custom Mode
You can set your time and flow rate according to your preference.
Feeding Mode
During your feeding period you can select this to stop the flow of your pump.
SETTING YOUR CUSTOM MODE
Press either Custom1 or Custom2 to create your custom flow rates.
Select Time. In Custom Modes you must set up at least 4 timers.
Press Hour and Minute and scroll up or down to select time.
Press Confirm.
Select AM/PM
Toggle Flow Rate to set your pump flow.
Save and continue until you have set up your desired schedule.
SETTING YOUR CUSTOM MODE
Once you have set up your schedule Press Custom1 or Custom 2 to run the pump
according your desired preference.
MAINTENANCE
CAUTION— Always unplug before performing any maintenance.
NEVER use soap detergents or any non-recommended cleaning agents around
an aquarium
ALWAYS rinse parts with cold water after cleaning
Cleaning/Replacing Impeller
Clean impeller by rinsing under cold water.
Remove any debris that could be restricting impeller rotations.
Call our Customer Service Department if replacement impeller is needed.
877-374-9981
WARRANTY INFORMATION
1 Year Limited Warranty
This ACCELA PRO is warrantied to the original purchaser against defective material and workmanship for 1 Year from the date of original purchase. This warranty is valid only under the following conditions: additions, modifications, or changes made to the product by the purchaser and not by the manufacturer shall void this warranty. Damages brought on by abuse, misapplication, or mishandling also voids this warranty.
This warranty is limited to the repair or replacement of the product at the discretion of the manufacturer. This warranty does not cover personal injury, property loss, including livestock or damage (direct, incidental, or consequential) arising out of use of this product. This warranty gives you specific rights and you may also have other rights, which may vary from state to state.
This warranty card must be filled out completely and returned within (14) days from the date of purchase. Failure to do so will void this warranty. A proof of purchase from an authorized dealer must be provided when making a warranty claim.
Upon discovery of a defect, please call us to obtain an RMA #.
Tel: (877) 674 9981
All claims should be sent prepaid to the following address:
Transworld Aquatics Enterprises, Inc.
3730 Unit 3, West Century Blvd.
Inglewood, CA 90308
Please Fill Out Completely and Return within 14 days from date of purchase.
(Please Print)
Customer Name:
Address: __
City: __
State: ____
Zip:_____
Phone#: __
Email:____
⬜Yes I would like to receive emails on JBJ News—New Products, Sales,
Rebates
⬜No I do not want receive emails on JBJ News
Date of Purchase: _
Model___
Dealer Purchased From:
Date of Purchase:
Please mail warranty registration and Proof of Purchase to:
Transworld Aquatics Enterprises, Inc.
Attn: Warranty Dept.
3730 Unit 3, West Century Blvd.
Inglewood, CA 90308
You can also register your product on our website—JBJAQUARIUM.COM
Transworld Aquatic Enterprises, Inc
3730 W. Century Blvd #3
Inglewood, CA 90303
Phone: 877-374-9981