VEGA 118440011 Slow Juicer Extractor User Manual
- June 9, 2024
- VEGA
Table of Contents
- VEGA 118440011 Slow Juicer Extractor
- GENERAL
- Product characteristics
- Schematic diagrams for parts
- Assembly Marking line
- Assembly of the squeezing rubber pad
- Disassembly of the squeezing rubber pad
- Cleaning
- Troubleshooting.
- WARRANTY
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
VEGA 118440011 Slow Juicer Extractor
GENERAL
Before the first use, read these instructions carefully. Always follow the safety and operating instructions. Keep the instructions for future reference. Do not use the appliance for purposes other than intended. Important: This appliance can be used by children over 8 years only under supervision. Do not play with the appliance. Never leave the appliance or its cord unsupervised, or within reach of children under 8.
IMPORTANT SAFEGUARDS
- Do not plug the product into a socket connected to other appliances that consume a lot of energy, and provide for the installation of a 30mA differential switch.
- To avoid electric shock, use the product as described in the manual.
- It is absolutely forbidden to immerse the product, the power cord or the plug in water or other liquids.
- Monitor the product during operation to avoid accidents.
- If any parts of the product or structure are damaged (especially the protection circuit or the mains cable), do not use the centrifuge.
- Do not try to repair it yourself, but contact a service center.
- Do not let children or disabled people use the equipment unless under the supervision of an adult.
- Do not use the product near stoves or heat sources.
- Do not use your fingers, spoons or chopsticks to press the food into the container.
- During use, do not touch any of the moving parts.
- Do not insert metal parts or objects into the motor body, to avoid short circuits.
- Always disconnect the machine from the mains before cleaning or storing it or when not in use.
- Do not place it near flammable objects.
- If the power cord is damaged, have it replaced by qualified personnel.
SHORT CORD INSTRUCTIONS
The appliance has a short cord in order to reduce the risk of getting entangled in or tripping over a longer cord. Extension cords may be used if care is exercised in their use.
- The electrical rating of the extension cord should be at least 16 ampere. An extension cord of less than 16 ampere could overheat and get damaged.
- If you use a longer cord, arrange it properly so that it does not drape over the counter top or table top, where it could be pulled on by children or tripped over
Product characteristics
- The appliance features a non-grinding juicing method which involves slow squeezing so the natural flavour and nutrients contained in fruit and vegetables are well retained. The appliance has been designed for juicing fruit and vegetables.
- The squeezing cup may be separated from the main body for a more convenient cleaning.
- The appliance has a dual switch for greater safety
Notes : The juicer has been designed for family use. Do not use it for commercial purposes so as not to shorten its service life
- Do not connect the appliance to the same power supply with other high-power electric appliances. Use a 30A leakage circuit breaker.
- To prevent electric leakage or other hazards, use the juicer according to these instructions.
- Do not leave the appliance unattended when in operation.
- Do not use your fingers, spoons or chopsticks to push fruit/vegetables into the feed inlet.
- Do not touch or move any moving parts during the appliance’s operation.
- Do not insert any metal sheet or other conducting materials into the juicer, so as not to cause fire or short circuit.
- Do not put the appliance near inflammable goods.
- Hold the plug with your hands when pulling it out. Never pull the power line or touch the cord with wet hands.
- Make sure the juicer stands on a firm plane.
- Always pull out the power plug after use.
- Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use.
- Always disconnect the appliance from the power supply if it is left unattended and before assem- bling, disassembling or cleaning.
Schematic diagrams for parts
Assembly Marking line
- Stopper
- Insert the squeezing cup into the main body so that it is fixed in the marked position.
- Put the stopper on the juice outlet.
Put the squeezing barrel into the washing rack.
- Insert the assembled squeezing barrel and washing rack into the squeezing cup
- Insert the spiral propeller into the squeezing barrel. Rotate the spiral propeller lightly to its right position
- Install the squeezing body cover
- When it is installed downwards, the marking point on squeezing body cover shall align with that on the squeezing cup.
- 3 Make “ ” at the back of the protruding part of squeezing body cover rotate towards “ ” on squeezing cup in clockwise direction and lock.
- See the figure. Place the juice/marc receiving cups in their appropriate positions (the two cups have the same overall dimensions).
Assembly of the squeezing rubber pad
-
* After the squeezing rubber pad is pulled out for cleaning, insert it back as indicated in the picture below.
- Wash the fruit/vegetables. If their sizes are larger than that of the feed inlet, cut them into blocks with proper size. Put the fruit/vegetables into the feed inlet and push inwards with the pushing rod.
- If the juicer stops suddenly during operation, press the “stop” button first, and then press the “reverse” button to push the fruit/vegetables in the spiral propeller upwards
- After the s queezing process is completed, press the stop switch, and pull out the power plug.
Disassembly of the squeezing rubber pad
- Power off to stop the appliance, and pull the power plug out.
- Hold the squeezing body cover with your hands anti- clockwise
- Take the squeezing body cover out when it is rotated to the position indicated in the figure.
- Hold the juicer outlet on the squeezing cup. Shake it lightly and take it out
- Take the spiral propeller + squeezing barrel + washing rack module out of the squee- zing cup
- Disassemble the spiral pro- peller, squeezing barrel and washing rack module
Cleaning
-
* Wash the disassembled parts with running water. If the meshes are blocked up by dreg, use the cleaning brush for the cleaning.
- Note: Do not use iron wire brushes, abradants or any sharp tools for cleaning.
- Do not put the main body in water for cle- aning. Clean the main body with a wringed soft cloth.
- Let the parts dry after cleaning, and store them in a clean and ventilated place.
Notes for use:
- Please read the following contents before use
- Put the fruit/vegetables into the juicer slowly, one by one. Add new fruit/vegetables only after the previous batch has been squeezed.
- Fruit/vegetables with large fibre content (such as celery) should be put into the juicer after being cut into blocks of approx. 1-2 cm (Fruit/vegetables with particularly strong fibre shoud be put into the juicer slowly after being cut into blocks of about 3cm).
- For carrots which have been stored at low temperature for over one year, it is recommended to squeeze them together with some fruit/vegetables with large water content (such as pear or orange).
- The amount of juice will be greater when new batches are put into the juicer after previous batches have been squeezed.
- The amount of juice will vary depending on the fruit/ vegetables water content.
- The amount of juice will be small if fruit/vegetables are not fresh.
- When using dry fruit/vegetables that have been stored in a refrigetor first immerse them in clear water for sufficient water absorption.
- Do not juice hard products such as kudzu, sugarcane, etc.
- There will be certain friction noise when carrots or apples are used for squeezing. It has no impact on the process.
- When squeezing such products as cherry tomatoes or grapes, some juice may splash from the feed inlet.
Product specification and main parameters
- Nominal Voltage : 220 – 240V
- Nominal Frequency: 50 – 60Hz
- Nominal Power consumption: 150W
- Nominal time: ≤20min
Troubleshooting.
CONFORMITY OF THE PRODUCT
The producer Melchioni Ready S.r.l. declares that the product Slow Juicer Mod. VEGA (cod. 118440011) is in compliance with Directive 2014/30/EU of the European Parliament and of the Council, of 26 february 2014, on the harmonisation of the laws of the Member States relating to electromagnetic compatibility. The producer Melchioni Ready S.r.l. declares that the product Slow Juicer Mod. VEGA (cod. 118440011) is in compliance with Directive 2014/35/EU of the European Parliament and of the Council, of 26 february 2014, on the harmonisation of the laws of the Member States relating to the making available on the market of electrical equipment designed for use within certain voltage limits. The producer Melchioni Ready S.r.l. declares that the product Slow Juicer Mod. VEGA (cod. 118440011) is in compliance with Directive 2009/125/EC of the European Parliament and of the Council, of 21 october 2009, establishing a framework for the setting of ecodesign requirements for energy- related products. The producer Melchioni Ready S.r.l. declares that the product Slow Juicer Mod. VEGA (cod. 118440011) is in compliance with Directive 2011/65/EU of the European Parliament and of the Council, of 8 june 2011 and subsequent Commission Delegated Directive 2015/863, on the restriction of the use of certain hazardous substances in electrical and electronic equipment. According to Directive 2012/19/EU of the European Parliament and of the Council, of 4 july 2012, on waste electrical and electronic equipment (WEEE), the presence of the crossed-out bin symbol indicates that this appliance is not to be considered as urban waste: its disposal must therefore be carried out by separate collection. Disposal in a non-separate manner may constitute a potential harm to the environment and health. This product can be returned to the distributor when purchasing a new device. Improper disposal of the appliance constitutes misconduct and is subject to sanctions by the Public Security Authority. For further information, contact the local administration responsible for environmental matters.
WARRANTY
Melchioni Ready s.r.l., based in Milan (Italy), via Colletta 37, recognizes a conventional guarantee on the product for a period of two years from the date of the first purchase by the consumer. This guarantee does not affect the validity of the legislation in force concerning consumer goods (Legislative Decree 6 September 2005 n. 206 art. 128 and following), of which the consumer remains the owner. This guarantee applies to the entire territory of the European Union. The components or parts that are found to be defective for ascertained manufacturing causes will be repaired or replaced free of charge through the dealer, during the above warranty period. Melchioni Ready S.r.l. reserves the right to make a complete replacement of the device, if repairability is impossible or excessively expensive, with another device of similar characteristics (Legislative Decree 6 September 2005 no. 206 art. 130) during the warranty period. In this case, the validity of the warranty remains that of the original purchase: the service provided under warranty does not extend the warranty period. In any case, this appliance will not be considered defective in terms of materials or manufacture should it be adapted, changed or adjusted, in order to comply with national or local safety and / or technical standards, in force in a country other than the one for which it is was originally designed and manufactured. This appliance has been designed and built for domestic use only: any other use will invalidate the benefits of the guarantee. The warranty does not cover:
- parts subject to wear or tear, nor those parts that require periodic replacement and / or maintenance
- professional use of the product
- malfunctions or any defects due to incorrect installation, configuration, software / BIOS / firmware update not performed by authorized Melchioni Ready S.r.l.
- repairs or interventions carried out by persons not authorized by Melchioni Ready S.r.l.
- manipulation of assembly components or, where applicable, of the software
- defects caused by falls or transport, lightning strikes, power surges, liquid infiltrations, opening of the appliance, bad weather, fire, public disturbances, inadequate ventilation or incorrect power supply
- any accessories, for example: boxes, bags, batteries, etc. used with this product
- home interventions for convenience checks or presumed defects
- The recognition of the guarantee by Melchioni Ready S.r.l. is subject to the presentation of a tax document that proves the actual date of purchase.
- The same must not show any tampering or deletions, in the presence of which Melchioni Ready S.r.l. reserves the right to refuse the provision of treatment under warranty.
- The warranty will not be recognized if the serial number or model of the appliance is non-existent, abraded or modified.
- This warranty does not include any right to compensation for direct or indirect damage, of any nature, to people or things, caused by any inefficiency of the appliance. Any extensions, promises or services in this regard, insured by the retailer, will be borne by the latter