MODSTER Ultralight Electric Scooter User Manual

Ultralight Electric Scooter
User Manual

ULTRALIGHT
E-SCOOTER

Delivery content

The first steps

2.1. diagram for reference

1. Battery indicator
2. Speed indicator
3. Plus button
4. Power on/off button
5. Minus button
6. Driving mode / speed level
7. Odometer mileage and remaining kilometers (range)
8. Throttle lever

2.2 Introduction of the button functions
Speed switch
The scooter has 3 different levels: Level 1, Level 2 and Level 3!
The lowest speed level is level 1.
The highest speed level is level 3.
You can select the desired level by pressing the button to increase the speed (+) or the button to decrease the speed (-).
On/Off button
Press the on/off button for longer than 2 seconds to switch on the e-scooter.
Press again for longer than 2 seconds to switch the e-scooter off.
Switch for the desired display
Your LED display can show you the following:
State of charge, speed, mileage, voltage and time.
You can determine the content by briefly pressing the on/off button
TRIP = Daily mileage
VOL = Voltage in volts
TIME = Power-on time
ODO = Totoal mileage
Brake and throttle lever
Press the brake button to decelerate.
Press the acceleration button to accelerate.
Lights
If you press and hold the on/off button, above the front light, for a longer period of time, you can turn on the light.

Connect the charger

Insert the charging plug into the charging port.
Note that two connectors must be aligned with each other.

Assembly of the handle

Screw in the handles and tighten them.
Before each ride, check the handles for tightness.

Instruction: folding and unfolding

Fold in

1. Hold the folding lever firmly & pull it.
2. Push the handlebar backwards..
3. When the e-scooter is folded in, you will hear a clicking sound.

Fold out

1. Pull the release lever and set the handlebar upright. It must audibly click into place!
2. The center position serves as the parking position!

Safety instructions

You must always wear a helmet and protective equipment when driving!
Driving in public traffic and busy residential areas should be avoided.
Please keep in mind that driving in public traffic involves some safety risks. Read the instructions in the user manual carefully and follow them to protect yourself as well as others. You should be aware that when driving on public roads or other public areas, you may face the risk of traffic violations or unauthorized operation by other persons or vehicles.
The e-scooter is built for one rider only. Riding with children or more than one person at a time is not allowed. You are not supposed to ride on stairs or escalators.
When approaching a bump, elevator sill, or pothole, do not go faster than 3-10 mph or even stop. Please note that the braking distance is also longer when driving an E-Scooter at higher speeds. Full braking on a slippery surface can cause the wheel to start slipping, you lose your balance and may even fall. Therefore, you should be alert while driving, maintain the proper speed and an appropriate safe distance from other people/vehicles.
Please respect the right of way when driving.
Avoid scaring pedestrians and especially children.
When riding in countries and areas without local national standard and rules related to scooters, you must strictly follow the safety requirements. We do not assume any responsibility for property damage, personal injury, accidents, litigation or other undesirable events caused by disregarding the user manual. We do not assume any direct  responsibility and joint liability.
To avoid damage, do not lend the device to people who do not know how to use it. When you lend the e-scooter, always educate about the product and also point out that it is necessary to wear a helmet as well as protective equipment when riding.
Never charge the e-scooter battery unattended.
Range data, as well as data on maximum speeds and the climbing capacity are strongly dependent on parameters such as the charge status of the battery, the condition of the surface, inclines or declines during the ride, the weight of the rider, physical effort by diving or if available, use of the pedals, weather conditions, headwind and other factors.
Our specifications refer to the optimum case.
Please always check the e-scooter for function and damage such as loose screws, etc. before riding it. Please do not continue driving if you notice any defects or malfunctions.
Contact our customer service for professional advice on product maintenance and service!
Always check…
…whether all parts of the e-scooter are installed correctly and have no damage,
….whether the brake is in order and works,
…if the battery is sufficiently charged,
…if the tires are in a good condition,
…whether the handlebars are tight.
…whether all screws & levers are tight or locked.
Please don‘t…
…drive on wet or soft ground -> not more than 2cm water!
…drive in during bad weather, snow or drive on icy roads!

1. Read those operating instructions carefully before driving!
2. This is not a toy -> children under 16 should not ride the e-scooter!
3. If you are physically unfit/ill or under the influence of medication or alcohol, you should not ride the e-scooter! Also not if you are mentally impaired or pregnant.
4. Incorrect assembly of the e-scooter can lead to loss of control, collisions or falls. Use the appropriate tools when assembling. Screwing too tightly or too easily can lead to damage and malfunctions.
5. Never modify or repair the e-scooter yourself or by unauthorized third parties.
6. The tires are pneumatic. Incorrect air pressure can lead to instability, damage or even traffic accidents. You should measure the tire pressure before each ride.
7. Before charging the e-scooter, check if the socket is dry, clean and free from malfunctions or objects. Keep children and animals away when charging. Make sure that there are no flammable substances nearby.
8. You must never disassemble the battery, perform irrational operations with it, or use it in an irrational manner.
9. Do not wear inappropriate footwear such as high heels or clothing that is too loose or inappropriate while riding. Always wear appropriate protective gear.
10. When you ride the e-scooter, you should wear protective glasses to keep dirt, dust or insects away from your eyes.
11. Do not attempt any fast turning maneuvers or tight turns at high speed or on wet surfaces. You could lose control.
12. Do not attempt to be pulled by other vehicles with the e-scooter. Avoid stunts and extreme sports actions.
13. The e-scooter is a personal travel device made for short distances. It should not be used for.

Daily maintenance

Storage and cleaning
If stains appear on the surface of the e-scooter, wipe them off with a soft and damp cloth. For stubborn stains, you can first wipe the e-scooter with a soft cloth. Then with a damp cloth. You must never spray the E-Scooter vigorously or with a high-pressure cleaner!
Do not clean the E-Scooter with alcohol, gasoline, kerosene or other corrosive and volatile chemical solvents, otherwise the appearance and internal structure of the vehicle will be severely damaged.
Never leave the e-scooter switched on during cleaning. Unplug the charging cable and plug the charging rubber cover. Otherwise, you could get an electric shock or serious problems could occur due to water spilling over.
Store your e-scooter in a dry and shady place when you are not using it. Do not place the escooter outdoors for long periods of time. Outdoor sunlight, overheating or
hypothermia will accelerate the aging of the appearance and wheels or even reduce the battery life.
Battery maintenance
Please do not leave batteries in an environment above 50°C or below -20°C.
Do not place the E-Scooter in the heat, otherwise there is a risk that the batteries will discharge, overheat or even start to burn.
In addition, the batteries may have longer life and performance at normal temperatures.
When used at below 0°C, battery life and performance will be reduced. Battery life may not increase at below 20°C until the temperature is increased.
Please also read the nameplate of the batteries under the vehicle to know the other maintenance instructions of the batteries.
Avoid charging when the batteries are completely discharged.
Instead, try to charge the batteries early and often.
With fully charged batteries, the stored energy is exhausted after 30 days in stand-by mode.
The stored energy is depleted after 14 days in stand-by mode if the battery was not fully charged.
If you do not charge the e-scooter in time, this may cause damage to the batteries.
This damage cannot be repaired.
The damage caused by long time not charging can not be repaired free of charge.
Note: Non-expert persons are prohibited from disassembling the battery.
This may cause serious accidents due to electric shock or short circuit.
Do not store the e-scooter with empty batteries! Before storing it, you should at least partially charge it and also recharge it regularly (e.g.: 1x per week) to avoid storage damage.

Technical data

depending on road, weight
Range:| 8 -10 km depending on weight
Climb angle:| 15°
Operating temperature:| 0°C to 40°C
Storage temperature:| -10°C to 50°C
Battery data| Rated voltage:| 25.9 V
Input voltage:| 29.4 V
Battery capacity:| 4.0 Ah
Engine data| Engine size:| 6.5 Inch
Power:| 250 W
Charger data| Rated input voltage:| 100 V – 240 V
Rated output voltage:| 29.4 V
Rated current:| 1A
Loading time:| 4-5 h

Disclaimer of Warranties

The maximum total weight and load must not be exceeded. High loads in connection with overloading operation of the device can lead to structural damage.
Jumping with the device is not allowed and leads to loss of warranty!
The same applies to driving through potholes and similar.
Driving on cobblestones leads to increased wear!
Only one person is allowed to drive at a time!
The device is designed for operation on flat and smooth surfaces.
It must not be used on sandy, muddy, wet, slippery, icy or snowy surfaces. icy or snowy surfaces. Driving during rain and snowfall is not permitted.
Do not disassemble or repair the device without authorization.
This will result in LOSS OF WARRANTY.
Avoid contact with salt water and do not expose the device to a salty atmosphere.
Do not store the device with empty batteries. The state of charge of the battery needs to be checked each month and recharged if needed.
Cleaning the device with high-pressure cleaners or a garden hose is not permitted. allowed.
Only wipe with a damp cloth!
Depending on the load, the device is subject to more or less wear.
This can lead to deflection of the steering, wheel bearings, folding mechanism and similar!
This is not covered by the warranty.
Brakes, tires, drive chains and sprockets are wear parts and are also not covered by the warranty.
The drive battery is designed for 200 charging cycles. A gradual decrease in performance cannot be avoided and is not covered by the warranty.
Store the device in dry places at a temperature between 10° – 30°C!
Only use the original charger! Never charge unattended!
Do not exceed the design speed of the device.
This can easily be exceeded, especially when driving downhill.

MSG Online GmbH
Konformitatserklarung Declaration of Conformity
Hiermit wird erklatt, dass folgendes Produkt: MODSTER Ultralight e-Scooter
Artikelnummer: 286286 (EAN: 4260668086082) in seiner
Manufactured in accordance with the following harmonised standatrls:

1. EMC Directive 2014/30/EU EN-61000-3-3:2013 + A1:2019
   EN 55032 EN 301 489-1 V2.2.0 (2017-03)
   EN 301 489-17 V3.2.0 (2017-03)

2. Machinery Directive 2006/421EC
   EN ISO 1210:2010 EN 60204-1:2006 + A1:2009

3. Low Voltage Directive 2014/357EU (For Charger)
   EN-60335-1:2012 + A11:2014 EN 62233:2008

4. Rolls Directive 2011/65/EU

Manufactor/ responsible Person:
MSG Online GmbH, Walter Bittdorfer Wirtschaftspark 9 8530 Deutschlandsberg, Austria

Walter Bittdorfer managing director
Place of issue / Date: 6
Deutschlandsberg (Austria), 04.01.2021

References

• MODSTER

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>