PICHLER Hughes 300 Flitezone 6 Axis Gyro 4 Channel Helicopter User Manual
- June 9, 2024
- PICHLER
Table of Contents
300 Flitezone 6 Axis Gyro 4 Channel Helicopter
User Manual
SAFETY INSTRUCTIONS
Please read the manual before start playing. This helicopter is not a toy and not suitable for children under 14 years of age. Only fly in open areas with no obstacles, away from any spectators and animals. Rotating propeller can cause severe injuries. Keep away from rotating propellers and protect your eyes with adequate protection. Always keep safety distance to the flying helicopter. When not in use, always unplug the battery and store in fireproof, cool and dry places. Only use the supplied charge lead to charge the battery. Always keep batteries away from children. If swallowed, call medical help immeditately. Do not dismantle batteries, do not throw in fire and do not expose in heat and/or sunlight.
KIT CONTENT
- Helicopter
- Radio Transmitter
- LiPo Battery
- USB Charge Lead
- Tools
- Instruction Manual
Radio Transmitter Functions
Parts Description
Charge Battery
Lipo Battery can be charged at your PC’s USB port.
- Plug USB charge lead into PC
- Connect LiPo battery to charge lead, red light= charging, no light= charging completed
Charge Lead can also be plugged into a mobile phone power supply or Power Bank, to charge the battery.
Flight Preparations
Make sure flight battery and transmitter batteries are full.
Choose a flying area which is free of obstacles, apart from traffic,
spectators and power lines. Rotor blades should move freely and not tighten
too much, otherwise the helicopter can cause vibrations. For emergency
situations, you can press the emergeny button (left top side) on the radio
transmimtter for 3 seconds which will cause the motors to stop. If emergency
stop is performed during flight, it may cause crashing.
Steering Functions
Gas
Throttle
Ruder
Rudder
Elevator
Aileron
Starting Prodcedure
- Turn on transmitter with helicopter standing nearby.
- Attach LiPo battery to Helicopter.
- LED lights on Helicopter and Transmitter are blinking. Transmitter makes acoustic signal and lights are always on, binding sucessful.
- Pull both joysticks to outer angles downwards to start helicopter. You can also press the one-key auto take off button.
- To land the helicopter, pull back throttle for 3 seconds and then release until motors stop. You can also use the auto land function by pressing the auto land button on your radio transmitter.
Beginners should pay attention to the direction of flight.
Fine Tuning -Adjustment
If the Helicopter has yaw problems during hovering, it can be fine tuned using the trimming buttons on the radio transmitter during flight.
Forward
Backward| 
| Fine tuning
according direction of arrow
---|---|---
Left
Right| 
| Fine tuning
according direction of arrow
Side| 
| Fine tuning
according direction of arrow
Gyro Calibration
To calibrate Gyro Sensors place Helicopter on leveled surface. Pull both control sticks to down left position. LED on helicopter flashes fast, then acoustic signal. If LED on Helicopter lights up, calibration is finished.
Spare Parts and Service
eMail an [email protected] Unerlaubte Einsendungen
werden nicht angenommen!
Spare parts for this product are available.
Please ask your dealer or visit
www.shop.pichler.de
