Danfoss RLV-D Angled Lockshield Installation Guide
- June 9, 2024
- Danfoss
Table of Contents
RLV-D Angled Lockshield
Installation Guide
RLV-D Angled Lockshield
Specification
| Compression | Push-fit |
|---|
Copper pipe:
According to BS2871 Part 1 / BS EN1057.
Max. temp. 120°C, Max. pressure 10 bar| Copper pipe:
According to BS2871 Part 1 / BS EN1057.
Max. temp. 92°C, Max. pressure 3 bar
Plastic pipes:
According to BS7291. Max. temp. 92°C. Max.
pressure 3bar
Cutting the pipes
1.Cut the pipe square ensuring that it is free from score marks and burs.
For plastic pipe we recommend the use of a plastic pipe cutter, do not use a
hacksaw
2.For plastic pipes, it is essential that a pipe insert is used. This must be
of the same make as the pipe. It is important to ensure that all internal burs
are removed from the pipe end prior to fitting the insert. Do not use any
lubricant.
Mounting – Compression
Ensure the pipe is pushed to the pipe stop
IMPORTANT: Both nuts have to be tightened
Mounting – Push-fit
Ensure the pipe is pushed to the pipestop in the elbow
IMPORTANT: Both nuts have to be
tightened
It is good practice to check the fitting before use: pull the pipe back to
check it is secure.
Dismounting: ensure system is de-pressurised. Push collet
squarely into elbow and firmly pull out pipe
Isolation and Regulation
Removal of protective cap|
---|---
Isolation|
Regulation| 
Danfoss A/S
Heating Climate Solutions
heating.danfoss.com
+45 7488 2222
E-mail: heating@danfoss.com
Any information, including, but not limited to information on selection of
product, its application or use, product design, weight, dimensions, capacity
or any other technical data in product manuals, catalogues descriptions,
advertisements, etc. and whether made available in writing, orally,
electronically, online or via download, shall be considered informative, and
is only binding if and to the extent, explicit reference is made in a
quotation or order confirmation. Danfoss cannot accept any responsibility for
possible errors in catalogues, brochures, videos and other material. Danfoss
reserves the right to alter its products without notice. This also applies to
products ordered but not delivered provided that such alterations can be made
without changes to form, fit or function of the product. All trademarks in
this material are property of Danfoss A/S
or Danfoss group companies. Danfoss and the Danfoss logo are trademarks of
Danfoss A/S. All rights reserved.
AN000086406205en-010102
– Part No. 013R9670
© Danfoss Climate Solutions
01.2023
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>