LEDlife NorDim250-Box Bell Press Dimmer Module Instructions
- June 9, 2024
- LEDlife
Table of Contents
LEDlife NorDim250-Box Bell Press Dimmer Module
BELL PRESS DIMMER MODULE 250W LED
Item No: NorDim250-Box
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOsION OR ARC FLASH
- Turn off all power supplying this equipment
- Use a voltage tester of appropriate rating
Failure to tollow these instructions will result in death or serious injury.The NorDim250-Box is a compact size to install behind a push switch. The trailing edge dimming technique ensure more stable dimming performance and noiseless. With min.& max. brightness adjustment and dimming speed adjustment, to solve most of the dimming problems it might be. You may need to refer to these instructions if you change your lights to a different type at a later date so please keep them for reference.
Features
- Trailing edge and four wires installation.(Neutral Required)
- With Min. & Max. brightness adjustment to avoid flickering.
- With Dimming Speed adjustment to adjust the dimming speed when you push it.
- Without hearable noise.
WIRING
- Disconnect power to the relevant circuit at the main switchboard.
- Remove the existing switch from the wall.
- Connect the dimmer in accordance with the wiring diagrams shown below.
- Refit the switch plate to the wall.
- Reconnect power.
- Turn the switch on and check the dimmer operation by turning the control knob through full range.
LED DIMMER SWITCH: 5-250VA/W
- Operating Voltage 220-240 V
- Frequency 50 Hz
- Maximum Load 300W/VA
- Minimum Load 5W
- Dimming Mode Trailing Edge
- Control Method One way or multiway
- Dimmable LED lamps 5-250VA/w
- LV Halogen lighting with 10-300W electronic transformers
- Incandescent lighting 10-300W
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>