MEGALODON 20103591 Monster Jam RC 1:24 User Manual

MEGALODON 20103591 Monster Jam RC 1:24

OVERVIEW

CAUTION: Hair Entanglement – Tie back and cover hair and secure loose clothing prior to play.

For in-depth video instructions go to

Spin Master International SARL, hereby declares that the radio equipment type MEGALODON™ is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://doc.spinmaster.com

WARNING: CHOKING HAZARD – Small parts. Not suitable for children under three years.

Frequency Band(s): 2.411－2.472 GHz Maximum radio frequency power transmitted: 10dBm.

CONTENTS

• 1 Megalodon™

• 1 Controller / 1 radio commande

• 1 Instruction Guide

HOW TO INSTALL BATTERIES

HOW TO DRIVE

DIRECTIONAL CONTROL

HOW TO FIX DRIFTING

HOW TO INSTALL BATTERIES

1. Open the battery door with a screwdriver (A). If used batteries are present, remove these batteries from the unit by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.
2. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
3. Replace battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.

HOW TO DRIVE

1. Turn on the vehicle and place on a flat surface.
2. Push the throttle lever up to the maximum position (1) and back to minimum position (2) to complete the connection.
3. You are ready to drive. 4. Use the remote control to drive.

For TROUBLESHOOTING questions and solutions, please visit our website:MONSTERJAMRC.COM

NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.

SAFETY PRECAUTIONS

– Keep hands, hair and loose clothing away from the motor/ wheels when power switch is turned ON.
– Remove battery(s) from controller when not in use.
– Parental guidance is recommended for the play.
– Keep your toy in your sight so that you can supervise it all the time.
– New alkaline batteries are recommended for use in controller to obtain maximum performance.
– Users should keep strict accordance with the instruction manual while operating the product.
Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy

REQUIRES 5 x 1.5V AAA (LR03) BATTERIES (not included)

Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life it should not be disposed of with other household waste. The Waste Electrical and Electronic Equipment Regulations require it to be separately collected so that it can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.

CARE AND MAINTENANCE

Always remove batteries from the toy when it is not being used for a long period of time (controller only). Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat. Do not submerge the toy in water. This can damage the electronic assemblies.

BATTERY SAFETY INFORMATION

Requires 5 x 1.5V AAA (LR03) batteries (not included). Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable- rechargeable batteries are to be removed from the toy before being charged. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

FCC STATEMENT

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:

• Reorient or relocate the receiving antenna
• Increase the separation between the toy and the radio or the TV
• Consult the dealer or an experienced TV-radio technician for help.
• Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.

BATTERY REQUIREMENT FOR TOY
Power Supply: ⎓
Rating: DC 4.5V, 0.675W
Batteries: 3 x 1.5 V AAA (LR03)
Requires 3 x 1.5 V AAA size batteries
(not included)
Power Supply: ⎓
Rating: DC 3 V, 0.45 W
Batteries : 2 x 1.5 V AAA (LR03)
Requires 2 x 1.5 V AAA size batteries
(not included)
UK – 0800 206 1191, serviceuk@spinmaster.com
IRELAND – 1800 992 249 NORTH AMERICA

References

• doc.spinmaster.com
• MONSTERJAMRC.COM
• monsterjamrc.com
• spinmaster.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>