Comfort Zone CZHV20S Series 20 Inch High Velocity Slim Drum Fan User Manual
- June 8, 2024
- Comfort Zone
Table of Contents
Comfort Zone CZHV20S Series 20 Inch High Velocity Slim Drum Fan
Features
- ON/OFF Switch with Speed Settings
- Adjustable Vertical Tilt
- Maximum Air Movement
- All Metal Construction
- Metal Fan Blades
- 120V A.C. / 60Hz
INTENDED USE
This product is intended for indoor residential and office use only, not for
industrial or other commercial applications. Use only electrical wiring that
is in good working order and that meets applicable codes and ordinances. If
you have any questions about whether your wiring is adequate, consult a
qualified electrician.
While using your fan, you should follow the IMPORTANT INSTRUCTIONS listed
below. As part of those instructions, we have used the word “WARNING” to
indicate the level of a hazard:
WARNING indicates a hazard that, if not avoided, could result in injury or death.
IMPORTANT INSTRUCTIONS
As with all electrical appliances, basic safety precautions should always be followed to reduce the risk of electric shock, fire, or injury to persons, including the following precautions:
- Read all the instructions before using this fan.
- Use this fan only as described in this manual. Any other use not recommended by the manufacturer may cause electrical shock, fire or injury to persons.
- Do not operate the fan with a damaged power cord or after the fan malfunctions or has been dropped in any manner.
- Use of extreme caution is necessary when any fan is used by or near children, disabled persons or pets and whenever the fan is left operating unattended.
- Do not place the fan on a small, unlevel, uneven or any surface that might allow fan to tip or fall.
- For proper operation, fan should be placed on a smooth, non‑combustible, level surface.
- Always unplug the fan when not in use, when moving from place to place, when assembling or disassembling parts, and before cleaning.
- The use of attachments, not recommended or sold by the manufacturer, may cause hazards.
- Do not use outdoors.
- Do not use a fan in the window. Rain may cause electrical hazards (for non‑window models).
- Do not operate the fan with blade guards or any safety device removed.
- Avoid the use of extension cords due to the risk of fire. If an extension cord must be used, the cord must be a minimum of 14 AWG and rated not less than 1875 watts.
- Do not run the power cord under the carpeting. Do not cover the cord with throw rugs, runners, or the like. Arrange the cord away from the traffic area where it will not be tripped over.
- Do not insert or allow any object to enter any openings on the fan. Doing so may cause electric shock and/or fire hazards. Avoid contact with moving parts.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure they do not play with the appliance.
READ & SAVE THESE INSTRUCTIONS!
WARNING: SHOCK HAZARD
Use your fan only in dry environments. This fan is not intended for use in a
bathroom, laundry area, or similar locations, or near sinks, washing machines,
swimming pools or other sources of water. Never locate fan where it may fall
into a bathtub or other water receptacle. Do not use in damp environments such
as flooded basements.
WARNING: HOT SURFACES
Do not touch fan motor when in use. This motor is hot when in use, to avoid
burns, do not let bare skin touch hot surfaces.
WARNING: FIRE HAZARD
Fans have arcing or sparking parts inside. Do not use near combustible
materials or flammable gases or sources of heat. Do not use in areas where
gasoline, paint or flammable materials are used or stored. To prevent a
possible fire, do not block air intakes or exhaust in any manner. Do not
insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock, fire, or damage the fan.
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate electrical system that
is up to code.
CAUTION:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, do not use this product with any
solid‑state speed control device.
WARNING: PREVENT ELECTRIC SHOCK
This product has a cord with a 3‑prong grounding‑type plug (A) which fits the
3‑slot grounded receptacle (A2). DO NOT remove the grounding prong (A1) if
only a 2‑slot receptacle (B) is available.
For connecting a 3‑prong grounding‑type plug to a 2‑slot receptacle, use an ADAPTER (C). The grounding lug (C1) extending from the adapter must be connected to a permanent ground with the Metal Screw (D) such as a properly grounded outlet box (E).
The adapter should not be used if a 3‑slot grounded receptacle is available.
DO NOT DEFEAT THE SAFETY PURPOSE OF EITHER A GROUNDED PRONG OR A GROUNDING
LUG
- DO NOT operate any fan with a damaged cord or plug or after fan malfunctions, has been dropped or is damaged in any manner. Do not operate fan with a broken blade, safety cage or any visual imperfections. Disconnect power before servicing. For repairs covered under warranty, see warranty statement. For all other repairs contact Comfort Zone® Customer Service by telephone or mail for information and assistance.
- DO NOT run the power cord under the carpeting. Do not cover the cord with throw rugs, runners or the like. Arrange the cord away from the traffic area where it will not be tripped over. Avoid the use of extension cords due to the risk of fire. If an extension cord must be used, the cord must be a minimum of 14 AWG and rated not less than 1875 watts. Do not use an extension cord unless the plug can be completely inserted into its receptacle. Unplug the fan when not in use. Do not operate the fan with its ventilation obstructed.
ASSEMBLY INSTRUCTIONS
Fan Cradle Assembly:
Simple assembly is required to use this fan.
- Align Cradle Base (packed separately) with support brackets attached to the fan body sides. Note: you may need to flex the parts to make them align properly.
- Insert the support bracket into the opening of the Cradle Base. Press the spring-loaded button down to allow it to insert into Cradle Base, see Fig 1.
- Press the support bracket into Cradle Base until the spring button protrudes out an open hole in Cradle Base, see Fig. 2.
- Repeat the above process for the opposite side of the fan.
USAGE
- Fan Operation: Always operate the fan in the upright position following all instructions and recommendations listed in this manual.
- Fan Location: Place the fan in the area of the room that will provide proper fan cooling.
- Fan Connection: Plug the fan directly into 120 volts A.C., 60 Hz wall outlet. Be sure the plug fits tightly in the outlet. A loose connection may cause overheating and damage to the plug or fan.
- Note: To prevent overloading a circuit, do not plug the fan into a circuit that is servicing other electrical needs.
- Turning Fan On: Place the fan on a stable level surface. Plug the fan into a properly grounded outlet. To start the fan, turn the switch from the OFF position to the desired fan speed.
- Turning Fan Off: To turn the fan off, turn the switch from the current fan speed setting to the off position. Remove the plug from the outlet.
- Adjusting Fan Tilt: To adjust the tilt angle, use supplied knob wrench to loosen the adjustment screw. After adjustment, retighten the adjustment screw. Save the knob wrench for future use.
CARE AND MAINTENANCE
Cleaning
CAUTION
Before cleaning the fan be sure to disconnect power cord from the plug. Clean
the grille surface with a clean damp cloth. Do not use harsh chemical or
abrasive cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES IN WATER. Allow fan to
dry completely before use. Periodic grille cleaning with a vacuum will prevent
dust build up. The motor is sealed and does not require any interior
maintenance, cleaning or lubrication.
Maintenance
The Internal motor bearings are permanently lubricated at the factory and do not require any additional lubrication.
Repair:
DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN PLACE. DO NOT USE THE FAN IF IT
HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
Storage:
Keep the original carton for storage of the fan. Coil and tie the power cord
to avoid damage during storage.
Note:
Some models come with a plug where you can replace a fuse. If your model has
this, please read and follow the below instructions to replace the fuse.
This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuits situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short‑circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair.
Fuse Replacement
-
Grasp the plug and remove it from the receptacle or other outlet device. Do not unplug by pulling on the cord.
-
Open the fuse cover by sliding open fuse access cover on top of the attachment plug towards the blades. See Fig. 2
-
Remove the fuse carefully. Use a small tool to pry the end of the fuse from the holder cavity. Be careful not to break glass windows.
-
Replace fuse.
WARNING: Risk of fire. Replace fuse only with identical 2.5 or 5.0 Amp, 125 Volt fuse (3.6mm x 10mm). Be sure fuse is properly seated within its cavity. -
Close the fuse cover by sliding it back to its original closed position.
LIMITED WARRANTY
This unit is guaranteed to the original retail purchaser against defects in quality or workmanship for a period of one year from the date of original purchase. If this unit fails because of a manufacturing defect within 30 days of purchase, return the unit, with your receipt, to the retailer. After 30 days, but within the warranty period, if the unit was purchased within the continental United States, return it, freight prepaid, to World and Main for repair or replacement.
If the unit was purchased outside the continental United States, return the unit to the place of purchase. This warranty does not cover damage caused by misuse, abuse, overheating or alteration. Repairs made by anyone other than World and Main are not covered in this warranty. World and Main will not be held liable for any losses due to neglectful operation. All implied warranties, including the warranties of merchantability and of fitness of purpose, if applicable, are hereby limited in duration to the period of one year from the date of the original retail purchase.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. Incidental or consequential damages arising from a breach of either express or implied warranties are hereby disclaimed and excluded. Some states do not allow the exclusion of limitation of incidental or consequential damages, so this limitation or exclusion may not apply to you. Upon the expiration of this warranty, all such liability will terminate. No other warranties are expressed or implied.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. No informal dispute settlement mechanisms are available. This limited warranty is given in lieu of all other warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800‑221‑6895
www.comfortzoneproducts.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>