NINJA Foodi CO351B 1200W Power Blender Processor System User Guide

NINJA Foodi CO351B 1200W Power Blender Processor System

What’s in the Box

Intelligent preset programs combine unique blending and pausing patterns that do the work for you. Once a preset program is selected, it will start immediately and automatically stop when blending is complete.

TIP: The unit can detect which container is installed on the motor base.
Only the functions available for a particular container will illuminate on the control panel.

• Go manual for total control of your blending speed and textures. Dial down the speed for heavy loads like dough, or crank up the speed for smoothies. Continuously runs up to 60 seconds. Press START/STOP at any time to end program sooner.
  NOTE: In Manual mode, Auto-iQ® programs will not illuminate on the control panel.

USING VARIABLE SPEED CONTROL & THE POWER BLENDER & PROCESSOR PITCHER
NOTE: IF USING MANUAL SPEEDS WITH THE DOUGH BLADE ASSEMBLY, ONLY USE SPEEDS 1 OR 2.

START SLOW
Always start at a low speed (1–3) to better incorporate ingredients and prevent them from sticking to the sides of the vessel.

DIAL UP THE SPEED
Smoother blends call for higher speeds. Low speeds are great for chopping veggies and mixing dough, but you’ll need to ramp up for purees and dressings.

HIGH-SPEED BLENDING
Blend until your desired consistency is reached. The longer you blend, the better the breakdown and smoother the outcome will be.

Assembling the Power Blender & Processor Pitcher

1. Holding the blade assembly by the top of the shaft, insert it into the pitcher.
2. Fill pitcher with desired ingredients. Install the lid, then lower lid handle to lock in place.
3. Place pitcher on base. Slightly align handle to the right so the LOCK symbols are visible on the motor base. Rotate clockwise until pitcher clicks into place.

Blending
PRESS THE POWER BUTTON TO TURN THE UNIT ON.

1. Use the dial to select an Auto-iQ® program or manual speed, then press START/STOP to begin blending.
2. When blending is complete, turn pitcher counterclockwise and lift to remove.
3. To pour out thinner mixtures, ensure lid is locked in place, then open pour spout.

NOTE: If using manual speeds with the Dough Blade Assembly, only use speeds 1 or 2.

For thicker mixtures
Press RELEASE button and lift handle to remove lid, then carefully lift out blade assembly before removing contents. Remove contents from blade assembly by using a spatula.

WARNING: Blade assembly is sharp and not locked in place. Make sure lid is locked onto pitcher before pouring contents. If pouring without lid, carefully remove blade assembly first. Failure to do so will result in a risk of laceration. Refer to the Ninja Owner’s Guide for additional information.

Dough making 101

Loading tips for making different doughs and batters.

COOKIES
Unit can make a max of 24 one (1) ounce cookies at a time.

1. Add sugars; cubed, softened butter; eggs; and liquids (such as vanilla extract). Use the dial to select DOUGH, then press START/STOP.
2. Add all dry ingredients and run the DOUGH program again. If more mixing is needed, run on Speed 2 until combined.
3. Remove dough blade and add mix-ins (such as chocolate chips, raisins, and nuts). Stir to combine.

PIZZAS, PRETZELS, BAGELS & BREAD DOUGHS

Unit can make a max of one 12″ round pizza, 8 pretzels or bagels, or one loaf bread at a time.

1. First add liquids (such as water), yeast, and oil.
   • Then add dry ingredients. Use the dial to select
   • DOUGH, then press START/STOP.
2. Remove dough ball and knead to combine, if needed.

BISCUITS, PIES & SCONES
Unit can make a max of 8 biscuits and scones or one 12″ round pie crust at a time.

1.  First add dry ingredients and cold, cubed butter or shortening. Use the dial to select DOUGH, then press START/STOP.
2. Add cold liquids (such as cold milk or water) and run the DOUGH program again. If more mixing is needed, run on Speed 2 until combined.
3. Remove dough ball and knead to combine.

CAKES, BROWNIES, MUFFINS & QUICK BREADS
Unit can make a max of one 12″ round cake, one 8″x8″ pan brownies, 12 muffins, or one 8″x4″ loaf of quick bread, such as banana bread or pumpkin bread.

1. Add sugars; oil or cubed, softened butter; eggs; and liquids (such as vanilla extract). Use the dial to select DOUGH, then press START/STOP.
2. Add all dry ingredients and run the DOUGH program again. If more mixing is needed, run on Speed 2 until combined.
3. Add mix-ins (such as chocolate chips, raisins, and nuts). Press iQ/Manual, and, with Speed 1 selected, press START/STOP. Blend until combined.

Food prep 101

PREPPING VEGETABLES

• Cut both ends off ingredients and remove any outer peels or skins.
• Cut ingredients such as carrots, cucumber, celery, and zucchini in 2″ pieces, and broccoli or cauliflower florets into 1″ pieces. Cut ingredients such as onions in quarters.

PREPPING MEAT

• Trim excess fat and connective tissue. Cut meat in 2″ cubes.

CHOP PROGRAM

• Timed pulses and pauses give you consistent chopping results.
• Run program once for a large chop, twice for a small chop, and three times for a mince.

*Assembling the XL Smoothie Bowl Maker Bowl & Nutrient Extraction Cup**

1. Fill container with desired contents. Screw on the blade assembly until you have a tight seal.
2. Flip container upside down and install on base. Rotate clockwise until it clicks into place.

Blending

PRESS THE POWER BUTTON TO TURN THE UNIT ON.

1. Use the dial to select an Auto-iQ® program or manual speed, then press START/STOP to begin blending.
   IF USING SINGLE-SERVE CUP, SKIP STEP 2.

2. If using the XL Smoothie Bowl Maker, twist the built-in tamper counterclockwise continuously while processing.

3. When blending is complete, remove the container from base. Then, remove the blade assembly from container.

Taking It To Go?
Place the Storage Lid or Spout Lid on top of the bowl maker or cup, and turn clockwise to seal.
NOTE: DO NOT microwave or freeze the XL Smoothie Bowl Maker or Single- Serve Cup.

SMOOTHIE BOWL BASICS
USING THE XL SMOOTHIE BOWL MAKER

1. Add milk, or milk alternative such as soy, coconut, almond, or oat milk, up to the LIQUID FILL line.
   ALWAYS DO THIS FIRST.

2. Add frozen fruit, directly from freezer, and/or açai or dragon fruit packets, up to the MAX FILL line. Cut larger fruit, like bananas, in quarters.
   If using açai or dragon fruit packets, thaw slightly and cut in quarters.

3. (Optional)
   Amplify your base by adding 1 scoop of yogurt, flavor powder, protein powder, and/or nut butter.

4. Screw on the blade assembly and install the bowl maker on the motor base.
   Select BOWL and press START/STOP. Twist the built-in tamper counterclockwise continuously while processing.

5. After blending is complete, add your favorite toppings, such as coconut flakes, granola, fresh bananas, berries, and agave nectar.

DID YOU KNOW?
Smoothie bowls are thicker & spoonable, compared to smoothies which are thinner & drinkable.

Cleaning

STUCK-ON INGREDIENTS IN THE XL SMOOTHIE BOWL MAKER?

NOTE: For best results, use a dishwasher to remove stuck-on ingredients.

1. Rinse the bowl maker and blade assembly under WARM WATER after processing.

2. Fill the bowl maker with warm water up to the top of the built-in tamper and add 1 or 2 SMALL DROPS of dish soap.

3. Select BOWL and press
   START/STOP. Twist the built-in tamper counterclockwise continuously while processing.

4. Once complete, empty contents and rinse under warm water.

NOTE: The built-in tamper in the XL Smoothie Bowl Maker is not removable.

STUCK-ON INGREDIENTS IN THE PITCHER OR CUP:
Fill pitcher with warm water up to the DOUGH MAX line and add 1 or 2 small drops of dish soap. For the cup, fill halfway with warm water and add 1 small drop of dish soap. Run the BOWL program. Once complete, empty contents and rinse under warm water. Refer to the Owner’s Guide for more information.

Dishwasher
Containers, lids, and blade assemblies are all dishwasher safe.

Hand-Washing
Wash containers, lids, and blade assemblies in warm, soapy water. When washing the blade assemblies, use a dishwashing utensil with a handle. Use the included cleaning brush to remove excess residue, such as when dealing with stuck-on ingredients, like doughs and batters.

WARNING: Handle the blade assemblies with care when washing, as the blades are sharp. Contact with the blades’ edges can result in laceration.

For questions or to register your product, visit us online at ninjakitchen.com

@ninjakitchen
© 2021 SharkNinja Operating LLC.
AUTO-IQ, FOODI, NINJA, and TOTAL CRUSHING are registered trademarks of SharkNinja Operating LLC. HYBRID EDGE is a trademark of SharkNinja Operating LLC. This product may be covered by one or more U.S. patents. See sharkninja.com/patents for more information. CO351B_QSG_REV_Mv5

References

• Sharkninja Home

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>