ring SF49E9 Outdoor Contact Sensor User Guide

June 4, 2024
Ring

ring logo User Guide
Outdoor Contact Sensor

Quick Start

ln-app Setup

  1. Make sure your Ring Alarm is disarmed.

  2. In the Ring app, open the menu.
    Tap Set Up a Device, then tap Security, tap Sensor, and find the Outdoor Contact Sensor.

  3. Follow the in-app instructions to complete the setup.

Installation

We suggest mounting the Outdoor Contact Sensor using more than one mounting method if needed. Make sure the Sensor and the Magnet are lined up, and 1″ apart or less.

Mounting Tape (included)
Use the included mounting tape, clean the area, then peel the backing and stick the Sensor. Press it to the surface and hold for 20 seconds to make sure the tape is securely attached.

Screws and anchors (included)
If mounting on a hard surface, use a 3/16″ (5mm) drill bit to drill holes for the anchors, then push them into place and screw in the brackets. If mounting on a softer surface  like wood, simply screw in the brackets.

  • 2 screws included: 3×21 mm
  • 2 anchors included: 5x25mm

Metal strap tie (not included)
Feed the metal strap tie through the back of the sensor and magnet brackets. Make sure that you tighten the strap tie so it doesn’t slide around or down the pole. If it does move around, consider also using screws to keep it in place.
Slide the Sensor and Magnet onto the mounting brackets when you’ve finished mounting them.

ring SF49E9 Outdoor Contact Sensor| ring SF49E9
Outdoor Contact Sensor - fig
---|---
ring SF49E9 Outdoor Contact Sensor - fig1| ring
SF49E9 Outdoor Contact Sensor - fig2

For additional help, visit: ring.com/help
Find online manuals at: ring.com/alarm-manual
For technical Z-Wave information, visit: ring.com/z-wave
© 2021 Ring LLC or its affiliates. Ring and all related marks are trademarks of Ring LLC or its affiliates. 22-003660-01

Important Product Information Renseignements important Relatifs au Produit

SAFETY INFORMATION

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC SHOCK, OR OTHER INJURY OR DAMAGE.

WARNING : Your device should only be used in accordance with the specific instructions for use and the intended purpose of the device. Using your device in any way other than its intended purpose could cause injury to yourself, and others and/or damage to the device or property.
WATCH FOR SMALL PARTS! Your device and accessories may present a  choking hazard to small children. Keep them out of reach of small children.
CAUTION: The device is not waterproof and as such should not be submerged in water, doing so could cause injury to yourself, others and/or damage to the device.
CAUTION: To reduce the risk of falling, take extra caution when using a ladder or similar equipment to mount the product. &

BATTERY SAFETY

This product contains alkaline batteries. This device requires batteries for use. Only use new 1.SV alkaline AA-sized batteries. Never mix old and new batteries. Keep all of the batteries out of the reach of children. Do not open, disassemble, puncture, cut, bend, shred or heat the batteries and do not allow metal objects to touch the battery terminals on the device as they can become hot and cause burns. Remove all batteries if they are worn out or before storing your Device for an extended period of time. Dispose of all batteries in accordance with applicable laws and regulations and do not dispose of batteries by throwing them into a fire. If any batteries begin to leak, take steps to prevent the fluid from coming into direct contact with skin or clothes as the fluid could be corrosive and may be toxic. Remove the batteries and clean the battery compartment in accordance with the battery manufacturer’s recommendations.

CAUTION : Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer. Dispose of the used batteries according to the manufacturer’s instructions.
Maintaining Your Ring Outdoor Contact Sensor
Use only accessories supplied with your device, or specifically marketed for use with your device, to power your device.

Product Specifications
Device Name : Ring Outdoor Contact Sensor
Model Number: 5F49E9
Electrical Rating: 2 AA Alkaline Batteries (1.5V)
Temperature Rating: – 4°F to 120°F (-20°C to 49°C)

RECYCLING YOUR DEVICE PROPERLY
In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of, or recycle, your device in accordance with your local laws and regulations. For  information about recycling your device, go to amazon.com/devicesupport

Term s of Service and Warranty
By purchasing or using the product, you agree to the Terms of Service found at ring.com/terms
For information on our warranty visit ring.com/legal

FOR CONSUMERS IN THE USA
Suppli er’s Declaration of Conformity Compliance
Information Statement
Unique Identifier: Ring Outdoor Contact Sensor
Model Number: SF49E9
FCC 10: 2AB2QSF49E9
Responsible Party and Party issuing Supplier’s Declaration of Conformity Ring LLC, 1523 26th St., Santa Monica, CA 90404 www.ring.com I legal@ring.com

FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This  device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to  provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not  installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,  which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/lV technician for help.

Pursuant to Section 15.21 of the FCC rules, changes or modifications to a Product by the user that are not expressly approved by the party responsible for compliance could  void the user’s authority to operate the equipment.
The device meets the FCC Radio Frequency Emission Guidelines.
Information on the product is on file with the FCC and can be found by inputting such Product’s FCC ID (which can be found on the device) into the FCC ID Search form available at fcc.gov/oet/ea/fccid
Information Regard ing Exposure to Radio Frequency Energy
The output power of the radio technology used in the Products is below the radio frequency exposure limits set by the FCC. Nevertheless, it is advised to use this product in such a manner that minimizes the potential for human contact during normal operation. This device should be installed and oper­ ated with at least 20 cm between the radiator and your body.
FOR CONSUMERS IN CANADA
Innovation, Science and Economic Development Canada (ISED) Compliance
IC ID: 10256A-SF49E9
This device contains licence-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Cana­ da’s licence-exempt RSS(s). Operation is  subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Information Regarding Exposure to Rad io Frequency Energy
This equipment complies with IC RSS-102 RF exposure limits set forth for an uncontrolled environment. This  equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.

Ring LLC 1523 26th St. Santa Monica, CA 90404 USA
0 2021 Ring LLC or ,ts affiliates.Ring and all related marks
are trademarks of Ring LLC or its affiliates.
For Z-Wave technical information, visit ring.com/z-wave.
Pour des informations techniques sur 2-Wave, visitez ring.com/z-wave
22-003667-01

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals