Burley Kickstand Bark Ranger and Bark Ranger XL Instruction Manual
- June 8, 2024
- BURLEY
Table of Contents
OWNER’S INSTRUCTION & SAFETY MANUAL
KICKSTAND MANUAL
BARK RANGER™ & BARK RANGER™ XL
BURLEY DESIGN
1500 Westec Drive
Eugene, OR 97402
P. 541.687.1644 or
800.423.8445
F. 541.687.0436
burley@burley.com
©2021 Burley Design LLC
“Burley” is a registered
trademark of Burley
Design LLC
MAN-00003_00
WARNINGS:
- Ensure kickstand is fully retracted before riding, failure to do so could cause accident or injury.
- Do not use kickstand without wheels attached to trailer.
- Always engage the trailer brake when using kickstand.
Burley Accessory Limited Warranty:
For full warranty details please visit:
www.burley.com/warranty
Set Up:
The Bark Ranger Kickstand can be installed on either the front or the back of the trailer. The assembly steps are the same for installation at either location.
The Bark Ranger Kickstand is sold in two sizes, before installation, ensure that the kickstand you purchased is the correct size. Hold the kickstand end up to the trailer mounting brackets and verify that the tubes rest on the outside surfaces of the mounting brackets (Fig. 1).
Tools Needed:
- 1x 4mm hex wrench
- 1x 8mm box wrench
Instructions:
- Unthread nuts and remove bolts, washers, and spring from kickstand tube (Fig 2).
- Insert kickstand onto trailer mounts (Fig 3).
- Slide bolt through the hole in the kickstand and the hole in the mounting bracket. Place plastic washer followed by spring, metal washer, and nut onto threaded side of the bolt (Fig 4).
- Using a 4mm hex wrench and an 8mm box wrench, tighten nut onto bolt until it is fully against the shoulder of the bolt (Fig 5).
- Repeat on other side.
- Rotate the kickstand to deploy, and it will snap into place. Before riding, ensure kickstand is fully retracted, failure to do so could cause accident or injury.
Figure 1
Figure 2 Figure 3
Figure 4 Figure 5
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>