DIAMOND MOWERS 15-2082 Wheel Weights Mounting Tools Installation Guide

Table of Contents

WARNING
Wheel weights are heavy and can cause severe injury or death. Use appropriate safety practices to avoid injury.

Place the insert tool(2) (part #24-0444) into the wheel weight(1) and slide it in until it is fully seated.
Secure the insert tool(2) to the wheel weight(1) with the supplied hardware(3).
Hardware(3) consists of (3) bolts (part #11-2130) and (3) flat washers (part #11-0070).
Slide the forks of your forklift together in the center of their adjustment.
Slide the fork tool(4) (part #24-0118) onto the forklift forks until fully seated.
Secure the fork tool(4) in place by tightening down the tension bolts(5).
Drive the fork tool’s(4) front spade into the slot in the center of the insert tool(2), and lift the wheel weight(1) / insert tool(2) assembly off of the ground.
Center the wheel weight(1) on the rim, and secure it in place with its supplied hardware at the (3) mounting locations(6) provided on the wheel weight(1).
NOTE : The fork tool(4) allows the wheel weight(1) to be rotated for easier installation.
Torque the hardware securing the wheel weight(1) to the rim to the specified torque values in your parts book or operator’s manual.
Back the fork tool(4) out of the insert tool(2), and remove the insert tool(2) with its hardware(3) from the wheel weight(1).
NOTE : This process may be repeated for additional / subsequent wheel weights(1).

WARNING
Wheel weights are heavy and can cause severe injury or death. Use appropriate safety practices to avoid injury

Slide the forks of your forklift together in the center of their adjustment.
Slide the fork tool(2) (part #24-0118) onto the forklift forks until fully seated.
Secure the fork tool(2) in place by tightening down the tension bolts(3).
Drive the fork tool’s(2) front spade into the slot in the center of the wheel weight(1) and lift it off of the ground.
Center the wheel weight(1) on the rim, and secure it in place with its supplied hardware at the mounting locations(4) provided on the wheel weight(1) that match the hole pattern on your rim.
NOTE : The fork tool(4) allows the wheel weight(1) to be rotated for easier installation.
Torque the hardware securing the wheel weight(1) to the rim to the specified torque values in your parts book or operator’s manual.
Back the fork tool(4) out of the wheel weight(1).
NOTE : This process may be repeated for additional / subsequent wheel weights(1).

WARNING
Failure to center and secure wheel weight(s) to the rim will result in failure and extreme damage