VOLT VAL-1813-40-BBZ Woodsman Single Source LED Downlight Instruction Manual
- June 8, 2024
- VOLT
Table of Contents
VOLT VAL-1813-40-BBZ Woodsman Single Source LED Downlight
INSTALLATION INSTRUCTIONS
- Make sure that the power is turned OFF before installing or servicing this fixture.
- This fixture is not intended to be installed within 10 feet [3 meters] of a pool, spa or fountain.
- This fixture is intended to be used only with a power supply (transformer) rated maximum of 300 watts (25 AMPS) at 12 volts.
- Underground Low Energy Cable must not be buried over 6” (15.2 cm) in order to connect to the main low voltage cable.
- Wiring connections must be made with wire connectors that are suitable for outdoor use.
- Position the wire connector so that it is located within 6 inches (15.2 cm) from a building structure, a luminaire, or fitting.
Important Safety Instructions
- Turn off/unplug and allow to cool before reducing lamp.
- Lamp gets HOT quickly!
- Do not touch the hot lens, guard or cowl.
- Keep lamp away from materials that may burn.
- Do not touch lamp at any time.
- Use a soft cloth.
- Oil from skin may damage lamp.
- Do not operate the fixture with a damaged or missing lens or shield.
Package Contents
- Fixture
- Screws
- Spacers
Product Dimensions
Install Fixture
- Determine the desired location for the fixture.
- Place the washers onto the self-tapping screws.
- Pass the self-tapping screws through the holes of the feet of fixture and spacers.
- Thread the self-tapping screws into the desired location to secure the fixture.
Wire Connections
Adjust Glare Guard Direction
Install / Replace Optic
Remove Glare Guard
Remove Fixture Lens
Replace Optic
Help Hotline
- 1-813-978-3700
- Mon-Fri 8am-8pm
- Sat-Sun 10am – 6pm (EST)
- Specifications and product details subject to change without notice.
- Copyright 2019, VOLT® Lighting, Lutz FL USA 33549
- All rights reserved
- customersupport@voltlighting.com
- 813.978.3700
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>