HINKLEY 1536LL LED Spot Light Instruction Manual
- June 8, 2024
- HINKLEY
Table of Contents
HINKLEY 1536LL LED Spot Light Instruction Manual
- Find a clear area in which you can work.
- Unpack fixture and glass from carton.
- Carefully review instructions prior to assembly
Save these instructions:
Note: This Luminaire is designed for use with Hinkley approved 12 volt landscape systems. Connection to other systems may cause premature failure or nonintended operation.
LUMINAIRE MOUNTING: (for typical ground stake mounting)
- To prevent electrical shock, disconnect transformer from electrical supply before installation or service.
- Run wire from Luminaire through mounting hole in top of ground stake.
- Attach Luminaire to ground stake by threading to the mounting hole in stake until it fits snuggly against the bottom of stem.
- Place stake in desired position and insert into ground until the flange of stake is flush with ground.
- Strip the two wire leads from the Luminaire and connect to the main supply wire using the provided silicone filled wirenuts.
The main low voltage cable from the luminaire is to be
-
Protected by routing in close proximity to the luminaire or fitting, or next to a building structure such as a house or deck.
-
The main secondary wire is intended for shallow burial – less than 6 inches (15.2cm)
– in order to connect to the main low voltage cable. -
Have the length cut off so that it is connected to a connector within 6 inches (15.2cm) from a building structure, a luminaire or fitting.
To lamp, place the spring on the back side of the lamp. Compress the spring and secure the floating socket to the lamp pins. Set lamp and spring in base. Place cowl over and secure with thumb screw.
H I N K L E Y L I G H T I N G 33000
Pin Oak Parkway Av on Lake, OH 44012
800 .446 .5539 / 440 .653 .5500
hinkley lighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>