AUDIO SYSTEM XFIT 100 BMW UNI HX EVO Speaker User Manual
- June 8, 2024
- AUDIO SYSTEM
Table of Contents
AUDIO SYSTEM XFIT 100 BMW UNI HX EVO Speaker User Manual
E-SERIES / F-SERIES / G-SERIES
Thank You
Congratulations on purchasing a high-quality
AUDIO SYSTEM product incl. GERMAN SOUND.
Important: Completely read this operating instruction before installation
and use of the device.
Attention: Pay attention to advice and instructions of the car
manufacturer. Check the polarity when connecting the speakers.
Important: You will need your purchase receipt as proof of purchase for
all warranty repairs and for insurance purposes. Keep your receipt, owner´s
manual and packing materials in a safe location for possible future use.
Attention: Use of sound components can impair your ability to hear
necessary traffic sounds and may constitute a hazard while driving your
automobile. AUDIO SYSTEM GERMANY accepts no liability for hearing loss,
bodily injury, or property damage as a result of use or misuse of our
products. We recommend installing the equipment by an authorized service
center or dealer. A professional fitting and connection are the requirement
for further warranty and perfect sound.
Crossover FWK TW EVO
Important: The speaker system can be adapted to the acoustics of the
vehicle, the genre of music and to the personal taste via the crossover.
Depending on the position of the speakers, the switch can be adjusted so that
the frequency response is optimized with these geometric conditions. Depending
on the installation location of the tweeter, it is necessary to adjust the
frequency response tonal and volume technology, e.g., when mounting the
tweeter in the A-pillar, in the mirror triangle or in the door trim.
Attention: Free cable ends must be isolated. Non-compliance can lead to a
short circuit!
USER MANUAL
| Color | Signal | Application |
|---|---|---|
| Red(4.8mm Plug) | Input + | To Connector 014 + |
| Black(2.8mm Plug) | Input – | To Connector 014 – |
| Red(Round Sleeve) | Tweeter + | Connect to Tweeter + |
| Black(Round Plug) | Tweeter – | Connect to Tweeter – |
| Jumper 2,7µF + Parking | -3dB (2.7µF) | Tweeter in Mirror Cover |
| Jumper 3,9µF + Parking | 0dB (3.9µF) | Tweeter in Door Panel |
| Jumper 2,7µF + 3,9µF | +3dB (6.6µF) | Tweeter in A-Pillar |
Midrange Speaker (Crossover FWK MID
Please connect the crossover FWK MID (INPUT) with FWK TW EVO (INPUT) and EX 100 SQ EVO3. It is a nonconfigurable fixed crossover.
Mechanical Installation Tip
Warning: First disconnect negative pole of your car battery. Checkpolarity, changing polarity may cause serious damage to your car electric. Best speaker positions are the original build in positions. Easy installation and original look are the reasons. Please note that the speakers are installed flat and stable. The quality of the installation decides the sound very much, therefore, attention should be paid to insulation and care during installation. Please note that the speakers are protected from heat, sunlight, mechanical influences, moisture, and wetness by accessories from AUDIO SYSTEM.
Attention: Install all cables as straight as possible without squashing
or laying them over sharp edges. Otherwise, this can cause short circuit or
damages to your whole installation.
Attention: Be careful removing original plastic parts of your car. The
fitting parts could be damaged and must be replaced.
Important: The right polarity of all speakers is extremely important
for the sound of your car audio system. We recommend changing polarity of the
tweeter finding out the best possible sound. The best is to listen and/or to
measure it.
Optional Mounting Accessories
- ALUBUTYL 1500, 2000 EVO and 3000 EVO, ALU 250 EVO Self Adhesive Damping Material
- Damping: Doorkit 1.0 and Doorkit 2.0
- Z-(T)SC 0.75, 1.5, 2.5, 4.0 Oxygen-Free Speaker Cable
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>