GAINSBOROUGH Avant Series with QuickFix Rivera Passage Lever Set Instruction Manual
- June 8, 2024
- GAINSBOROUGH
Table of Contents
Avant Series with QuickFixTM- Passage and
Privacy
Installation Instructions
Avant Series with QuickFix Rivera Passage Lever Set
Step 1.
-
Fold template where indicated.
-
Position template on door edge at desired latch height (suggested height is 970mm from floor).
-
Firmly hold template and mark latch height and handle fixing holes at 60mm backset (refer template).
-
Measure door thickness and mark centre.
-
Drill 25mm (1”) latch hole.
Note: it is important to drill this hole squarely. -
Drill one 50mm (2”) hole or one 54mm (2 ⅛”) hole through door face at required backset as marked on template.
Step 2.
- Mark and chisel door edge for latch face plate to a recess of 2mm or until flush with door. Use latch face plate as a template.
- Pre-drill wood screw holes with suitable drill size.
- Insert latch and fasten with wood screws provided.
Latch is included with selected passage sets only.
Latches can be ordered separately.
Step 3.
- Attach QuickFix furniture with preinstalled studs and screws.
Step 4.
- Install furniture.
Step 5.
- Rotate bezel to lock in place and tighten screws.
Step 6.
- Measure Ø8mm either side of centre mark, drill Ø25x15mm hole.
- Use strike as a guide to mark and chisel recess, allowing space behind strike plate for the dust box.
- Insert dust box, drill holes and screw strike in place.
Step 7.
- Fit rose cover.
Step 8. (For privacy function only)
- Fit privacy pin.
NOTE: Carefully follow these instructions when installing.
Screws to be hand tightened to a recommended 2.5Nm torque.
Fit here on door edge
Allegion (Australia) Pty Ltd
Freephone 1800 098 094
Email info.au@allegion.com
www.allegion.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>