Fur Daddy M31223 Pet Hair Remover Instruction Manual

: June 8, 2024
: Fur Daddy

Table of Contents

INSERTING THE BATTERIES #3
3](#3%5D%28https%3A%2F%2Fmanuals.plus%2Fwp-content%2Fuploads%2F2023%2F01%2FScreenshot_6-455.jpg%29)
Technical data
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Fur Daddy M31223 Pet Hair Remover Instruction Manual

(#1)
a. Hanging loop
b. Power button
c. Release button
d. Dust container
e. LED light
f. Micro-bristles

FOR BEST RESULTS (#2)

Press the POWER button on the handle. The vibration is activated and the lights switch on. (see figure a.)
$FOR BEST RESULTS $#2$$
When cleaning, pull/push the FurDaddy back and forth with short movements. Don‘t be disturbed by the clicking noise, it is completely normal; continue rolling backwards and forwards. Please note that the FurDaddy™ reel can only be rotated halfway, and not completely like a wheel. (see Figure b.)
$FOR BEST RESULTS $#2$$
When you‘re finished or the container is full, empty the dust container by pressing the release button on the side of the handle, and pouring the contents into the bin (see figure c.).

Close the container by pressing the door down until it clicks into place. To make sure that the container flap is well closed, it is recommended to press the flap tightly at the circled point (see figure a.).

WARNING:
Do not use on pets, people, wet surfaces, very thin pile carpets, deep
pile carpets or similar, or on hard surfaces.

NOTE:
For best results when cleaning, pull/push the FurDaddy back and forth with quick movements. Do not exert too much pressure on the surface to be cleaned and don’t be disturbed by the clicking noise – continue rolling backwards and forwards. To empty your FurDaddy, press the release button to the left of the handle.

INSERTING THE BATTERIES #3

INSERTING THE BATTERIES #3 ![INSERTING THE BATTERIES

3](https://manuals.plus/wp-content/uploads/2023/01/Screenshot_6-455.jpg)

INSERTING THE BATTERIES #3

To open the battery compartment on the back of the handle, use a Phillips screwdriver to remove the screws. Put the cover and screws to one side . (see figure 1a.)
Insert 2 AAA batteries (not included) as shown. (see figure 1b.)
Replace the battery compartment and tighten using the screws. (see figure 1c.)

MAINTENANCE
If the micro-bristles get dirty, clean them using a soft, damp cloth. DO NOT hold the bristle area directly under running water. Allow the micro bristles to air dry before using again.

STORAGE Store the FurDaddy™ in a cool, dry place. To hang up, extend the hanging loop from the end of the handle and hang it on a hook.

CAUTION:
Looking directly into the light could damage your eyesight. Only use in dry places. Do not place the FurDaddy™ to wet or damp areas. Do not allow liquid to get into the FurDaddy™. Do not immerse in liquids. FurDaddy™ is only intended for domestic use.