Amica AH4629 Chimney Extractor Hood Instruction Manual
- June 9, 2024
- Amica
Table of Contents
Amica AH4629 Chimney Extractor Hood
Dimensions
Instructions
Dear customer,
From now on, your daily housework will be easier than ever before. Your
appliance is exceptionally easy to use and extremely efficient. After reading
these Operating Instructions, operating the appliance will be easy.
Before being packaged and leaving the manufacturer, the appliance was
thoroughly checked with regard to safety and functionality.
Before using the appliance, please carefully read these Operating
Instructions. By following these instructions carefully you will be able to
avoid any problems in using the appliance. It is important to keep these
Operating Instructions and store them in a safe place so that they can be
consulted at any time. Follow these instructions carefully in order to avoid
possible accidents. Sincerely
NOTES ON SAFETY
- The appliance is designed for household use only.
- The manufacturer reserves the right to introduce changes, which do not affect operation of the ap-pliance.
- The manufacturer shall not be liable for any dam-age or fire caused by the appliance resulting from failure to follow instructions in this manual.
- Cooker hood is designed to remove cooking odours. Do not use cooker hood for other pur-poses.
- Connect the cooker hood operating in extraction mode to a suitable ventilation duct (do NOT con-nect the cooker to smoke or flue gas ducts, which are in use). It requires installation of the air ex-traction duct to the outside. The length of the duct (usually a pipe of Ø 120 or 150 mm) should not be longer than 4-5 m. An air extraction duct is also required for telescopic and furniture hoods in absorption mode.
- Cooker hood operating in air recirculation mode requires the installation of an activated charcoal filter. In this case, installing an extractor duct is not required, however it is recommended to in-stall an air guide vane (Mainly in chimney cooker hoods).
- The cooker hood features independent lighting and exhaust fan that can be operated at one of several speeds.
- Depending on the type, the hood is designed to be permanently attached to a vertical wall over a gas or electric stove (chimney and universal hoods); on the ceiling over a gas or electric stove (island hoods); on the vertical built in furniture over a gas or electric stove (telescopic and built-in hoods). Before installing, make sure that the wall/ceiling structure is strong enough to suspend the hood. Some hoods are very heavy.
- For details of the installation distance above an electric hob please refer to product technical sheet If the installation instructions of the gas cooker specify a greater distance, this must be taken into account (Fig. 1).
- Do not leave an open flame under the hood. When the pots are removed from the burner, set the minimum flame. Always make sure that the flame does not extend outside the pot, because it causes unwanted loss of energy and a dangerous concentration of heat.
- When cooking on fat, supervise the pans con-stantly, because overheated fat can ignite.
- Unplug the appliance before any cleaning, replac-ing the filter or repair work.
- Cooker hood grease filter should be cleaned at least once a month, because the filter saturated with fat is flammable.
- Ensure adequate ventilation (air flow) if other equipment such as liquid fuel stoves or heaters are operated in the room in addition the cooker hood. When the cooker hood is simultaneously operated with burning appliances requiring ade-quate fresh air from the room to work properly, their safe operation is possible if under pressure around these appliances is a maximum of 0.004 mbar (this does not apply when the cooker hood is used as an odour filter)
- Do not lean on the hood.
- The hood should be cleaned regularly both inside and out (AT LEAST ONCE A MONTH, following the indications concerning maintenance provided in this manual)..Failure to adhere to the rules con-cerning cleaning the hood and replacing filters results in a fire risk.
- If the power cord is damaged it should be re-placed by a specialised service centre.
- Ensure that it is possible to disconnect the ap-pliance from the mains by removing the plug or switching off the bi-polar switch.
- This appliance is not intended for use by persons (including children) with physical, mental or sen-sory handicaps, or by persons inexperienced or unfamiliar with the appliance, unless under su-pervision or in accordance with the instructions as communicated to them by persons responsible for their safety.
- Particular attention should be paid not to allow unaccompanied children to use the appliance.
- Make sure voltage indicated on the nameplate corresponds to the local mains supply voltage.
- Before use, extend and straighten the power cord.
- Packaging materials (bags, polyethylene, poly-styrene, etc.) should be kept away from children during unpacking.
- Before connecting the hood to the mains power supply always check that the power cord is prop-erly installed and is not trapped by the appliance. Do not connect the appliance to the mains until assembly is complete.
- Do not operate your kitchen hood without the al-uminium grease filters.
- It is strictly forbidden to cook dishes under on an open flame (flambé) under your kitchen hood.
- Always strictly adhere to regulations issued by the competent local authorities regarding the techni-cal and safety requirements for fume extraction.
- Failing to tighten bolts and fasteners in accord-ance with these instructions may endanger life and health.
- Hanging kitchen hoods operate only in air circu-lation / odour absorber mode
UNPACKING
During transportation, protective packaging was used to protect the appliance
against any damage. Af-ter unpacking, please dispose of all elements of
packaging in a way that will not cause damage to the environ-ment. All
materials used for packaging the appliance are environmentally friendly; they
are 100% recyclable and are marked with the appropriate symbol.
Important! Packaging materials (bags, polyethyl-ene, polystyrene, etc.)
should be kept away from children during unpacking.
DISPOSAL OF OLD APPLIANCE
In accordance with European Directive 2012/19/EU and Polish legislation re-
garding used electrical and electronic goods, this appliance is marked with
the symbol of the crossed-out waste container. This marking indicates that the
appliance must not be disposed of together with other household waste after it
has been used.
The user is obliged to hand it over to waste collec-tion centre collecting
used electrical and electron-ic goods. The collectors, including local
collection points, shops and local authority departments pro-vide recycling
schemes.
Proper handling of used electrical and electronic goods helps avoid
environmental and health haz-ards resulting from the presence of dangerous
com-ponents and the inappropriate storage and process-ing of such goods.
DESCRIPTION OF THE APPLIANCE
Below please find the description for the drawing of your appliance. Please refer to the drawing at the beginning of these operating instructions.
- Upper chimney cover
- Lower chimney cover
- Lighting
- Control Panel
- Air flaps
- Screws and wall plugs
- Upper chimney cover holder
- Wall holder
- Carbon filter
Install the appliance as shown in figure 3a…
OPERATION
Kitchen hood controls
Control Panel is shown in Figure 4, for reference it is also shown below
:
The control panel is equipped with touch controls:
To turn on the kitchen hood, touch one of the sensors to select the desired
speed:
- Low speed. Use this speed when cooking a little food with hardly any fumes.
- Medium speed. Use this speed when cooking multiple dishes at the same time with moderate amount of fumes.
- High speed. Use this speed when frying or grilling, with large amount of fumes.
- Turn Standby mode on/off
- Turn light on/off
Note:
- To use one of the three speeds, first touch the to turn on the Standby mode and then select the desired speed. To turn off the active speed, touch the backlit sensor again.
- To turn on the light, first activate the Standby mode.
- When you turn off the Standby mode, the appliance fan and light will turn off.
- Touch twice to turn off the hood when fan is operating.
Off-Timer
Use Off-Timer to turn off the hood after a specified time. Use Off-Timer to filter the fumes out of the air after cooking. The delay time is about 15 minutes. Touch to activate the Off-Timer at any time. Sensor flashes. Flashing indicates that Off-Timer has been enabled. Touch again to cancel the Off- Timer. The appliance will turn off. To turn on the appliance, touch the sensor corresponding to the desired fan speed.
Other important information concerning the operation of the hood
Operation in air circulation / odour filter mode. In this mode, the filtered
air returns to the room through the outlets. Install activated charcoal
filter in this setting. It is recommended to install the air guide (available
depending on the model, mainly in chimney cooker hoods).
Air extraction operation: When cooker hood operates in extraction mode, air is
discharged outside through an extraction duct. Remove activated charcoal
filter in this setting. The cooker hood is connected to the air outlet opening
using a rigid or flexible extraction duct with a diameter of 150 or 120 mm,
and the appropriate clamps, which must be purchased
at a hardware store. The appliance should be installed by a qualified
installer.
Fan speed: Lowest and medium fan speed is used in normal conditions and
less intense odours, while the highest speed is used only when cook-ing odours
are very intense, such as during frying or grilling.
Note (applies to universal hoods only): Due to the design of universal hoods
you need to manually change the mode of operation. See Figure 8 for
instructions on how to change the mode.
Note (only applies to telescopic and in-built kitchen hoods): Furniture and
telescopic cooker hoods operating in air recirculation mode require
installation of the exhaust duct. The other end of the duct should be di-
rected to the room as it will discharge filtered air.
Note: Hanging kitchen hoods operate only in air circulation / odour ab-
sorber mode
CLEANING AND MAINTENANCE
Maintenance
Regular maintenance and cleaning of the appliance will ensure trouble-free
operation of the cooker hood and extend its life. Especially make sure that
the grease filter and activated charcoal filter are replaced ac-cording to
manufacturer’s recommendations.
- Do not use a soaked cloth, sponge, or water jet.
- Do not use solvents or alcohol, as they may tarnish lacquered sur-faces.
- Do not use caustic substances, especially for cleaning stainless steel.
- Do not use a rough or abrasive cloth.
- It is recommend to use a damp cloth and a neutral detergent.
Note: After several washes in the dishwasher, the colour of the alumini- um filter may change. The change of colour does not indicate improprie-ties or the necessity to change it.
Grease filter
For normal hood operation, aluminium grease filter should be cleaned every
month in the dishwasher or by hand using a mild detergent or liquid soap.
Dismantling of aluminium grease filter is shown on Figure 5.
Acrylic filter is used in some models. This filter should be replaced at least
once every two months or more frequently if the appliance is used intensively.
Activated charcoal filter
Charcoal filter is used only when the cooker hood is not connected to the
ventilation duct. Activated charcoal filter can absorb odours until saturated.
Charcoal filter is not suitable for washing or regeneration and should be
replaced at least once every two months or more frequently if the appliance is
used intensively.
Dismantling of charcoal filter is shown on Figure 6.
Light
Use incandescent / halogen / LED modules of the same specification as those
factory-installed in the appliance. See Figure 7 for details how to replace
lights. If there is no such figure in this manual, please contact authorised
service to replace the lighting module.
WARRANTY AND AFTER SALES SERVICE
Warranty
Warranty service as stated on the warranty card. The manufacturer shall not be
held liable for any damage caused by improper use of the product.
The manufacturer recommends that all repairs and adjust-ments be carried out
by the Factory Service Technician or the Manufacturer’s Authorized Service
Point. Repairs should be carried out by a qualified technician only.
Manufacturer’s Declaration
The manufacturer hereby declares that this product meets the re-quirements
of the following European directives:
- Low Voltage Directive 2014/35/EC
- Electromagnetic Compatibility (EMC) Directive 2014/30/EC
- ErP Directive 2009/125/EC
- Directive RoHS 2011/65/EC
and has thus been marked with the CE symbol and been issued with a declaration
of compliance made available to market regulators.
Amica S.A.
ul . Mickiewicza 52 64-510 Wronki
tel. 67 25 46 100
fax 67 25 40 320
www.amica.pl
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>