Home Depot ECD50V-HDC Cast Iron Submersible Sump Pump User Manual

Home Depot ECD50V-HDC Cast Iron Submersible Sump Pump

Safety Information

CAUTION: Call an electrician when in doubt. The pump should be connected to a separate 12 A circuit breaker or 12 A fuse block. Plugging into existing outlets may cause low voltage at the motor. This could cause blown fuses, tripping of motor overload or a burned out motor.

ELECTRICAL SAFETY

WARNING: Verify that the voltage and frequency of the pump shown on the nameplate corresponds to those available on the mains. The installer must make sure that the electrical system is grounded in accordance with code.

• The plug and connection should be protected from water splashes, and should never be used with an extension cord. Before using the pump, always inspect it visually (especially power cord and plug).
• Do not use the pump if it is damaged.
• If the pump is damaged, have it inspected by an authorized service center.
• Make sure that electrical connections are protected from flooding. Protect the plug and the power cord from heat or sharp edges.
•  The power cord must be replaced by qualified personnel only. Grounding: The plug of the power cord has a double grounding contact, so that grounding can be achieved by simply inserting the plug9.

OVERLOAD PROTECTION
This pump series has a built in thermal protection switch. The pump stops if an overload condition occurs. The motor restarts automatically after it has cooled down.

Warranty

This product is guaranteed for a period of three years from the date of original retail purchase against defects in materials and workmanship.

• Subject to the conditions and limitations described below, this product will be replaced with the same model or one of equal value or
• specifications if the pump’s cord end with cord tag and proof of purchase are returned to the retail store within the stated warranty period.

These warranties are subject to the following conditions and limitations:

• a) a proof of purchase receipt verifying the purchase location and purchase data must be provided;
• b) this warranty will not apply to any product or part thereof which is worn or broken or which has become inoperative due to abuse, misuse, accidental damage, foreign materials in the system, operating at pressures in excess of recommended maximums, neglect or lack of proper installation, operation or maintenance (as outlined in the applicable owner’s manual or operating instructions) or which is being used for industrial, professional, commercial or rental purposes;
• c) this warranty will not apply to normal wear and tear or to expendable parts or accessories that may be supplied with the product which are expected to become inoperative or unusable after a reasonable period of use;
• d) this warranty will not apply to routine maintenance and consumable items such as, but not limited to, fuel, lubricants, vacuum bags, blades, belts, sandpaper, bits, fluids, tune-ups or adjustments;
• e) this warranty will not apply where damage is caused by repairs made or attempted by others (i.e. persons not authorized by the manufacturer);
• f) this warranty will not apply to any product that was sold to the original purchaser as a reconditioned or refurtbished product (unless otherwise specified in writing);
• g ) this warranty will not apply to any product or part thereof if any part from another manufacturer is installed therein or any repairs or alterations have been made or attempted by unauthorized persons;
• h) this warranty will not apply to normal deterioration of the exterior finish, such as, but not limited to, scratches, dents, paint chips, or to any corrosion or discoloring by heat, abrasive and chemical cleaners; and
• i) this warranty will not apply to component parts sold by and identified as the product of another company, which shall be covered under the product manufacturer’s warranty, if any.

ADDITIONAL LIMITATIONS
This warranty applies only to the original purchaser and may not be transferred. Neither the retailer nor the manufacturer shall be liable for any other expense, loss or damage, including, without limitation, any indirect, incidental, consequential or exemplary damages arising in connection with the sale, use or inability to use this product.

NOTICE TO CONSUMER
This warranty gives you specific legal rights, and you may have other rights, which may vary from state to state. The provisions contained in this warranty are not intended to limit, modify, take away from, disclaim or exclude any statutory warranties set forth in any applicable provincial or federal legislation.

Contact the Customer Service Team at 1-844-883-1872 or visit www.HomeDepot.com.

INSTALLATION REQUIREMENTS

This pump is provided with an on/off float switch for automatic operation. Refer to the Installation instructions included with switches and
controllers for installation.

• Care should be taken to prevent the pump from running in a dry sump.
• The pump must be installed in a suitable basin which is a minimum of 11 in. in diameter and a minimum of 24 in. deep.
• The pump must be placed on a hard level surface. Never place the pump directly on clay, earth or gravel surfaces.
• The pump can be installed with ABS, PVC, polyethylene or galvanized steel pipe. Proper adapters are required to connect plastic pipe to the pump.
• Always install a union in the discharge line, just above the sump pit, to allow for easy removal of the pump for cleaning or repair.
• A check valve must be used in the discharge line to prevent back flow of liquid into the basin. The check valve should be a free flow valve that will easily pass solids.
• When a check valve is used, drill a relief hole 3/16 in. in diameter in the discharge pipe. This hole should be located below the floor line between the pump discharge and the check valve. Unless such a relief hole is provided, the pump could “air-lock” and will not pump water even though it will run.
• A gate valve should follow the check valve to allow periodic cleaning of the check valve or removal of the pump.
• The remainder of the discharge line should be as short as possible with a minimum of turns to minimize friction head loss. Do not restrict the discharge to sizes below 1-1/2 in.

Please contact  1-844-883-1872 for further assistance.
HOMEDEPOT.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>