HyperX Cloud Mix True Wireless Headphone User Guide
- June 9, 2024
- HYPERX
Table of Contents
HyperX Cloud Mix True Wireless Headphone
Overview
- A 3.5mm cable port
- B Microphone port
- C USB charge port
- D Bluetooth® power button
- E Status LED
- F Bluetooth® volume buttons
- G Bluetooth® multifunction button
- H Bluetooth® microphone
- I USB charge cable
- J Detachable microphone
- K 3.5mm cable
- L Wired microphone mute
- M Wired headphone volume wheel
- N 3.5mm PC extension cable
Wired
Bluetooth® Wireless Technology
Questions or setup issues?
Contact the HyperX support team or see user manual at:
hyperxgaming.com/support/headsets
Battery/TX Power Info
Battery Information
- Contains 3.7 V, 600 mAh
- Li-ion Battery, 2.22Wh
- Cannot be replaced by user
Frequency & TX Power Information
- Frequency Bands:
- Bluetooth, 2.4GHz
- (TX Power: <4dBM )
Operation Temperature
- 0 to 45°C,
- 0 to 90% humidity
Regulatory Notices
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, according to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try correct the interference by one or more of
the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the
instruction manual.
Warning: A shielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference to the nearby radio and
television reception. It
is essential that only the supplied power cord be used. Use only shielded
cables to connect I/O devices to this equipment.
CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
Canada Notices
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Taiwan NCC Statement:
The Bluetooth® word mark and logos are registered trademarks owned by the
Bluetooth SIG, Inc. and any use of such marks by Kingston Technology Company,
Inc. is under license. Other trademarks and trade names are those of their
respective owners.
HyperX is a division of Kingston.
THIS DOCUMENT SUBJECT TO CHANGE WITHOUT NOTICE
©2019 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley,
CA 92708 USA.
All rights reserved. All registered trademarks and trademarks are the property
of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>