Oxayoi MT01 Magnetic Car Mount User Manual
- June 9, 2024
- Oxayoi
Table of Contents
MT01
User Manual
On The Dashboard
Magnetic Car Mount
YOUR BEST DRIVE PARTNER
Dear Customer
If you have any question please do not hesitate to contact us at anytime we
are always here if you need!
INSTALLATION GUIDE
Step 1
Unscrew the fixed nut completely. Let the ball joint pass through the fixed nut
(the thread must face to the groove).
Step 2
Push the ball joint firmly into the groove on the back of the car mount, then
tighten the fixed nut.
Step 3
Clean the dashboard with dry cloth.
Step 4
Put the magnetic mount on the dash and firmly press it. Hold in place for about
30 seconds.
Step 5
Let it sit for at least 24 hours before using to achieve the strongest
adhesion.
Step 6
Once the mount is secured in place, remove the protective film and set the
Metal Plate.
You may place the metal plate as following shows.
Opition 1
Installation between the case and device
Opition 2
Installation on the back of device
Opition 3
Installation on the back of the case
ATTENTION!!
Tips 1
Viscosity of VHB Sticky Tape
For better pasting, please kindly note:
- Cleaning the flat surfaces to ensure that there is no dust or oil.
- Do not leave fingerprints on the 3M sticky tape.
- When applying, please make sure that the temperature of the flat surface and the sticky gel should be above 68℉, or you may soften the 3M VHB tape under heating air before installation.
- Press for 8 to10 seconds after pasting.
- Recommended to use after 24 hours of pasting.
- Never uses the adhesion promoter on the metal surface.
Time of Viscosity
Time 20| Degree of adhesion
20 minutes| 50%
60 minutes| 75%
24 hours| 90%
3 days| 100%
Tips 2
Remove Dashboard Disk Pad
Use a thin plastic card to carefully lift the dashboard pad from the mounting
surface. Slowly lift up and remove it.（Remembernot too hard and move it
slowly）
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>