MAXIM LIGHTING 58710 Wafer LED Flush Mount User Manual
- June 9, 2024
- MAXIM LIGHTING
Table of Contents
MAXIM LIGHTING 58710 Wafer LED Flush Mount
Please consult a qualified electrician for hanging fixture and wiring.
Light Source : LED Integrated 10W / 15W / 20W 120-277V 50/60Hz
Made in China / Hecho én China /Fabrique en China
LED Lighting (LOW VOLTAGE)
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a cutter knife, be careful
not to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of small children.
Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you
intend to position the item.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
· Risk of suffocation!
Keep any packaging materials away from children.
Lighting
Instructions
Carefully read through the instruction sheet before assembly and using the
product.
Caution there is a risk of shock. Disconnect from power source before
assembling or cleaning.
WARNING: Wires need to be connected to driver found in canopy and
should not be connected directly to power source or a short may occur.
Do not cut factory connections unless instructed by the manufacturer
Do not plug the product in if cord is torn or frayed.
Cleaning & Maintenance
On polished finishes, often using talc powder
reduces the appearance of fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass
cleaner, acrylic polish, and wood polish.
Clean with soft cloth and a mild detergent. DO not use abrasive cleaner.
Periodically (every 90 days) make sure that the screws are fully tightened.
Prolonged exposure to heat sources may cause glazing, melting and scorching,
or even cause color to fade.
Contents
Before getting.started,ensure the package contains the following components:
INSTALLATION
- Prior to installation, install the mounting plate on the junction box with mounting screws. Drive screws completely to the end of the junction box.
- Connect supply wires to wires on fixture with wirenuts. Connect white to white, black to black and copper wire to copper wire as grounding connection.
- Completing the installation by pushing the fixture into the mounting plate.
WIRING DIAGRAM (ONLY FOR REFERENCE)
DO NOT ATEMPT TO CUT FACTORY CONNECTIONS WiTHOUT QUALIFIED KNOWLEDGE.
MODIFICATIONS
MADE TO THIS PRODUCT WITHOUT THE CONSENT OF THE MANUFACTURER WILL VOID
WARRANTY.
SCHEMATIC FOR GENERAL REFERENCE ONLY
THIS FIXTURE HAS BEEN TESTED TO DIM WITH . . .
- Lutron Diva DVCL-153P
- Lutron Diva DVELV-300P
- DEAKO-Smart Dimmer
- DEAKO-Single Dimmer
- Lutron Caseta
- Lutron Skylark S-600
- Lutron Diva DVLV-600P
- Leviton Sureslide 6613-P
- Leviton Illumatech IPI06-1LZ Leviton Decora 6674
Note: Triac dimmer only work at 120V
FOR TECHNICAL SUPPORT contact: qc@maximlighting.com
Must be installed by a licensed electrician with knowledge of electronic lighfing systems
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>