V-TAC VT-1112D LED Spotlights Instruction Manual
- June 9, 2024
- V TAC
Table of Contents
V-TAC VT-1112D LED Spotlights Instruction
INSTALLATION INSTRUCTION
TECHNICAL DATA
Model | VT-1112 | VT-1112D |
---|---|---|
Watts | 12 | 12 |
Base | GU10 | GU10 |
Lumens | 1021 | 1031 |
Beam Angle | 40° | 40° |
CRI | >90 | >90 |
PF | >0.9 | >0.9 |
Dimmable | NO | YES |
IP Rating | IP20 | IP20 |
Body Type | Plastic Clad Aluminum | |
Long Life | 20,000 Hours | 20,000 Hours |
Rated Current | 0.05A | 0.05A |
Dimension | Ø111x86mm | Ø111x86mm |
Input Power | AC: 200-240, 50Hz | AC: 200-240, 50Hz |
INTRODUCTION & WARRANTY
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at the best. The warranty is valid for 2 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.
WARNING
- Please make sure to turn off the power before starting the installation.
- Please connect directly to 220V
- Install only by certified Electrician.
- The product uses a very high power LED. As with any light source, direct viewing should be avoided.
Caution, risk of electric shock.
This marking indicates that this product should not be disposed of with other household wastes.
NOTE: Although easy to fit, this lamp requires wiring to the main and for safety should only be fitted by a qualified electrician.
NOTICE
- Lighting installation should not be covered. Leave some spaced around the fixture for ventilation
- Risk of shock, hence disconnect at fuse or circuit breaker before installation or servicing.
- Risk of fire, supply conductors (power wires) connecting fixture must be rated minimum 90°C. If uncertain, consult electrician
INSTALLATION REQUIREMENT
- Please connect with the driver properly before connecting to the main supply.
- The lighting should be located in dry area
INSTRUCTION INSTALLATION
- Switch off the power before starting the installation.
- Push into the GU10 holder and rotate clockwise
- Turn on the power and test if installation is done properly without mistakes.
NOTE: For Dimmable models, make sure that the GU10 holder is properly connected with the dimmer.IN CASE OF ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT: SUPPORT@V-TAC.EU FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST DEALERS. V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>