Shenzhen Twomonkeys Technology C602 Al Laser Printer User Manual
- June 9, 2024
- Shenzhen Twomonkeys Technology
Table of Contents
Twomonkeys Technology C602
Al Laser Printer
User Manua
Product Introduction
Dosmono’s Al laser pointer has built-in voice input. voice translation, same-
screen subtitles. and PPT page turning. laser. Support 112 languages
translation including Mandarin. Cantonese, English French, Italian, German.
Japanese. Korean etc. *Voice key
Click: turn on or off the same-screen subtitles.
Press and hold: you can control the computer cursor.
Release: turn ofl the control of the computer corsor
Hardware Installation
- Take out the USB signal receiver from the bottom of the laser pointer and insert it into the USB port of the device [desktop computer/notebook computed.
- Turn on the page-turning pen switch, and the green light will be on for 2 seconds after power-on. The USB signal receiver automatically recognizes and installs the hardware driver. After the installation is complete, Long press the voice button and move the laser pointer at the same time to move the computer cursor synchronously. The page turning pen and the USB signal receiver are matched by default when they leave the factory. If the laser pointer fails to recognize, please re-match and try again: first plug the USB signal receiver into the device. Turn on the power of the laser pointer and be within 10cm of the USB signal receiver. Press and hold the page up button and page down button at the same time for 3 seconds to enter the pairing mode. The laser pointer and the USB signal receiver will automatically match again.
[ATTENTION]
If the Laser pointer does not work prop-erly, it may be caused by a dead
battery. It is recommended that you charge it.
Software installation
- Under Windows system, press and hold the voice button and the page down button at the same time for more than 5 seconds to automatically open the down-load website interface. Select the software version of the corresponding system to download and install;
- Follow the prompts to install after downloading. After the installation is com-plete, it can run normally.
Precautions
-
The current Al Laser pointer supports WIN7, WINS, and WIN10 systems. [System Support ]
-
When replacing the laser pointer on the same computer, after the hardware driver is installed, directly double-click the software program icon to use the page turning pen normally.
-
The back-end program of the Laser pointer is updated in real time. If an error or other performance occurs during the use of thelaser pointer, you can uninstall the computer software program, reinstall the software program, then you can use it. [Software Update]
-
The official website of the Al laser pointer software download website: [Download URL] https://www.aipen.dos-mono.com
-
1After the software download is com-plete, please run the program after the installation is complete. When the icon of Laser pointer in the lower right corner of the screen is displayed normally, it’ s indicates that the program is running normally. When the program prompts “Please insert the USB signal receiver”,
[1] Please check whether the USB receiver is plugged in
[2] Please try to run the application again -
Currently voice input and voice trans-lation support 112 languages including: English, Traditional Chinese, Japanese, Korean, Russian, French, Spanish, Arabic, Portuguese, Bulgarian, Czech, Danish, German, Greek, Estonian, Finnish, Hun-garian, Indonesian, Italian, Latin, Dutch, Romanian, Slovenian, Polish, Swedish, Thai, Malay, Vietnamese, etc. [Voice trans-lation]
-
If the installation program is blocked by security software 1360 or Kingsoft Internet Security, etc.) or blocked by mistake, please close the antivirus software and install it again. It is recom-mended that you add the installer to the whiteList. [Installation Problem]
Instructions
Al laser pointer supports use on Windows system computers.
On-screen Subtitles
Open the application, select the voice recognition language, click the laser
pointer voice button, the same screen floating Layer will pop up, and the same
screen subtitles can be displayed through voice input.
PPT Page Turning
Open the PPT on the computer, in the slideshow mode, you can turn the PPT page
up and down through the page up key and the page down key.
Laser
Press the Laser button, the laser point-er can emit Laser, release the laser
button to turn off the laser.
Cursor Movement
Long press the voice button and then move the laser pointer to control the
cursor movement on the computer.
Note: This product is shipped without a power adapter. If consumers use a
power adapter to supply power, they should purchase a power adapter that has
been certified [COO certified and meets the standard requirements). The
battery must not be exposed to sunlight, fire or similar overheating
environments .
WARNING!
It is forbidden to disassemble, hit, squeeze or throw into fire. If severe
swell-ing occurs, do not continue to use it. Do not place it in a high
temperature environ-ment. Do not use the battery after it is immersed in
waterOnly dedicated char-gers can be used.
WARRANTY CARD
Thank you for purchasing Dosmono Al laser pointer! In order to better provide you with fast service, please fill user information in detail, thank you for your support!
Customer Information
Customer Name| | Date|
Product Model| | Contact Number|
Contact Address|
Distributors/Agents (Stamped,if have)|
Warranty Record
Warranty Date| Warranty Part| Remarks
| |
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>