FISHER PAYKEL AHD5-OBDD-60S Contemporary Square Fine Handle Installation Guide
- June 9, 2024
- Fisher & Paykel
Table of Contents
FISHER PAYKEL AHD5-OBDD-60S Contemporary Square Fine Handle
SAFETY & WARNINGS
WARNING: Cut Hazard
- Failure to use caution could result in injury.
- Take care: some edges may be sharp.
- For products that are not front-mounted, installation must be carried out by a Fisher & Paykel trained and supported service technician.
- Ensure all packaging is removed and disposed of responsibly.
- Installation of this product requires basic mechanical skills.
- Ensure the product is installed with the correct tools to avoid personal injury or damage to the appliance.
- Take care not to scratch the door with the supplied Hex key when tightening the screws.
COMPONENTS REQUIRED
Supplied
Not supplied
FITTING HANDLE TO PANEL
Custom panel installations
- Mark the handle location on the panel. Ensure distance between holes is 432mm.
Custom panel installations
- Drill the holes using a 6mm drill bit. Counterbore from the rear.
Align the pin locks to the front of the panel before inserting the supplied screws from the rear of the panel.
- Custom and Dishwasher panels: Countersunk screw
- DishDrawer panels: Pan head screw
- Secure pin locks by tightening the screws using a crosshead driver. Do not over-tighten.
- Loosen the grub screws and fit the handle onto the pin locks.
- Tighten the grub screws using the supplied hex key.
For more information, visit: www.fisherpaykel.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>