Coolblue Wall-mount Speaker Stand Installation Guide
- June 9, 2024
- coolblue
Table of Contents
Coolblue Wall-mount Speaker Stand Installation Guide
INSTALL SPEAKER STAND.
On a high note.
Materials
-
Standard,
-
screws,
-
plugs,
-
small bolt,
-
lightly larger bolt,
-
clamp,
-
cap
-
Crosshead screwdriver,
-
Drill (8 mm diameter),
-
crosshead bit,
-
Allen key (included,
-
drill,
-
spirit level,
-
pencil.
PREPARE THE STAND
On the back of the stand 1 is a plastic cap. Pull it off. It can be tough, so it takes some power.
MARK OFF THE DRILL HOLES
Mark off the holes on the wall through the two holes of the plastic cap. After drilling, check that it is hanging straight with the spirit level 13 .
DRILL THE HOLES
Use the 8 millimetre diameter drill 9 to drill two holes about five centimetres deep. Then press the plugs 3 into the holes and screw the plastic cap in place with the screws 2 .
HANG UP THE STAND
Press the small cap 7 into the wall mount so that you conceal the screws properly. Then press the stand 1 into the wall mount.
FIX THE STAND
Secure the stand at the bottom with the screwdriver 8 and a bolt 5 . After this, you can place the speaker on the stand and secure it at the top with the clamp 6 and the other small bolt 4 .
TURN AND TILT THE STAND
loosening the bolts on the side of the stand with the Allen key 11 included, turn and tilt the speaker in the correct position. You’ve finished! Or done, if you’re called Jan.
CHECKLIST. You’re 50% there.
Suitable surface:
- Solid brick
- Solid concrete
- Drywall with wooden pillars behind it
Prior to drilling:
Use the pipe locator to check if there aren’t any pipes or cables in the wall.
Do you have a question?
Coolblue.nl/en/ customer-service
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>