PHILIPS GU10 MasterConnect LED Installation Guide
- June 9, 2024
- Philips
Table of Contents
PHILIPS GU10 MasterConnect LED
Installation Guide
This Quick Installation Guide contains important information and notes regarding the installation of Philips MasterConnect LED GU I Os. Please read carefully before installation.
- Product is dimmable by wireless control. DO NOT use with a wall dimmer.
- Operate with direct mains only.
- Product must be used in dry environment and in luminaires that are approved for the application.
- Operating ambient temperature from -20°C to +45°C.
- Must be used with compatible control devices.
- Product should be use within specified radio-frequency (RF) communication range.
- This range can vary depending on actual application environment.
Follow the instructions below to install the product(s). Different systems may
require physical installation of devices at a different stage during system
setup.
You’re required to read the system guide to understand the complete and
proper sequence.
After power on, lamps will automatically search for available Zigbee network and connect to a Zigbee gateway (if any). Lamps can also be commissioned by using a designated Bluetooth mobile application. Please refer to our website for instructions on app download.
When needed, performing factory reset will restore a lamp to its default state. Lamp will be removed from its current network (if any) and all settings will be deleted.
-
The lamps can be reset from the system app when credentials are properly
kept and lamps are accessible. In this case please follow the in-app instructions. -
If credentials are lost, lamps will need to enter safe-mode in order to be reset.
Turn the lamps off for 5 seconds, then on for 5 seconds. Repeat 5 times to activate safe mode. Visit our website to download the tool for factory reset. Hereby, Signify declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.philips.com/lighting
SPECIFICATION
Wireless RF mode Frequency Range:
Bluetooth Low Energy: 2402-2480 MHz,
Zigbee: 2405-2480 MHz
Output power (Conducted):
Bluetooth Low Energy: 4dBm,
Zigbee: 4dBm
The Bluetooth® word and logos are registered trademarks owned by Bluetooth
SIG,INC.
DISPOSAL
Please inform yourself about the local waste disposal, separation and collection system for electrical and electronic products and packaging. Please act according to your local rules and do not dispose your old product and packaging with your normal – household waste. The correct disposal of the packaging, your product and/or batteries will help prevent potential negative consequences for the environment and human health. Batteries should be disposed separately from the municipal waste stream via designated collection facilities. When disposing a product that contains non-user replaceable batteries, the non-user replaceable batteries shall be removed by a professional.
© 2022 Signify GmbH, Unternehmensbereich Lighting
Signify I.B.R.S. / C.C.R.I. Numero I 0461
5600¥B Eindhoven, the Netherlands
Cll00B00-74454775
Layout und Produktion: Signify, Hamburg
www.philips.com/lighting Philips and the
Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used under license
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>