FISHER PAYKEL AAHP3DWDDSXP Professional Round Flush Handle Installation Guide
- June 9, 2024
- Fisher & Paykel
Table of Contents
FISHER PAYKEL AAHP3DWDDSXP Professional Round Flush Handle
SAFETY & WARNINGS
WARNING!
| Cut Hazard
Failure to use caution could result in injury.
-
Take care: some edges may be sharp.
-
For products that are not front-mounted, installation must be carried out by a Fisher & Paykel trained and supported service technician.
-
Ensure all packaging is removed and disposed of responsibly.
-
Installation of this product requires basic mechanical skills.
-
Ensure product is installed with the correct tools to avoid personal injury or damage to the appliance.
-
Take care not to scratch the door with the supplied Hex key when tightening the screws
COMPONENTS REQUIRED
Supplied
Handle (1)
|
M6x25mm pan head screw (2
|
M6x25mm countersunk 5mm hex screw (2)
|
5mm hex key (1)
---|---|---|---
Not supplied
Powered driver
|
Crosshead driver
|
Tape measure
|
Level
---|---|---|---
FITTING HANDLE TO PANEL
|
Custom panel installations: Mark the handle location on the panel. Ensure
distance between holes is 432mm.
---|---
|
Custom panel installations: Drill the holes using a 7mm drill bit.
Counterbore from the rear.
|
Align handle to the holes.
| Secure
handle by loosely tightening the screws using a crosshead driver. Do not
overtighten. Custom and Dishwasher panels: Countersunk screw DishDrawer
panels: Pan head screw
| Use
a level to confirm the handle is aligned. Tighten using the supplied hex key.
CUSTOMER SUPPORT
For more information, visit www.fisherpaykel.com