peripage ALD-L100 Mini Label Printer Instruction Manual
- June 2, 2024
- peripage
Table of Contents
peripage ALD-L100 Mini Label Printer
Product Sketch
-
Type-C
Charged with a power bank or mobile phone charger -
Power Button
- Press and hold 3 seconds to turn on/off
- Double-click to print the device connection QR code
-
Paper Outlet
Paper width 14mm -
Paper Cutting Button
- Press to cut paper
- Press to cut paper
Power Indicator Status
- The green light on: Normal use status.
- The red light on: Cover opened, please check the paper position and close the cover tightly.
- Red light flashes: Low power, please charge in time for low battery.
App Download
Search for “PeriPage” on google play or App store, or scan the QR code to download APP.
Download and Install the “PeriPage” App
Connect to print
Turn on the device, following the Peri Page App prompts to search and connect the printer. Or double-dick the power button to print the QR code, and scan the QR code to connect printer in Peri Page App.
Don’t connect the printer to the mobile phone’s Bluetooth settings.
Charging Instructions
- SV= lA input charging. Recommended using a mobile phone adapter for charging.
- Recommended to fully charge for the first time.
- If it is not used for a long time, please charge it every 3 months to avoid long-term natural loss of lithium battery.
Tips
- Operating ambient: 5°C-40°C ambient temperature, 45%-90%RH (Non condensing state).
- Please keep out of reach of infants and children after use.
- Don’t touch the cutter blade.
Replace sticky tape
- Rotate left and align, and open the cover.
- Put the paper into the paper storehouse.
- Rotate right and align, close the cover.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Xiamen iLead Tek Co., Ltd.
Room 01, Unit 2101, No.50 Chengyi North Street, Software Park Phase lll,
Xiamen, Fujian, China.
www.ileadtek.com.
service@ileadtek.com 400-8550-520.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>