SegenSolar Kodak 3.68kWh 48V Battery Module Instructions
- June 3, 2024
- SegenSolar
Table of Contents
Kodak 3.68kWh 48V Battery Module
Instructions
Kodak 3.68kWh 48V Battery Module
Application Note – How to connect BL3.6 battery to KODAK OG inverters
The following guide explains the set-up and configurations of the BL3.6 48V
Li-ion battery with the KODAK OG 48V inverter models.
Please ensure that the inverters and batteries are updated to the latest
firmware version.
Required
• RS485 cable – This cable is included with all KODAK OG inverters
Step one
Connect the power cables to the negative and positive battery terminals shown
on figure 1 below.
Step two
Connect the communication cable (Battery end) into the most left RS485 port of
the battery indicated on figure 2.
The BMS cable is included with the KODAK OG inverter in the box.
Connect the inverter side of the communication cable to the Li-
Ion port of the inverter indicated on figure 3.
Step three
• DIP Switch Definition and Description
Set the master batteries dip switch 1 to the ON position (up), for the first
slave batteries set dip switch 2 ON, for the second slave batteries set dip
switch one and two to ON, for the third batteries set dip switch 3 to ON (see
illustration below).
Maximum of 15 batteries in parallel is supported, and the address codes for
each battery must be different.
Step four
Using the switch shown below, switch on your battery. Monitor the LEDs, they
should be solid. When the LEDs start flashing, turn on the
inverter.
Step five
Enter the programming menu following the user manual of the inverter. Navigate
to program 05 and select PYL. This will ensure successful BMS communication.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>