blum EURO 230 Self Closing Slide User Manual
- June 3, 2024
- blum
Table of Contents
EURO 230 Self Closing Slide
User Manual
EURO 230 Self Closing Slide
LIMITED LIFETIME WARRANTY
SELF CLOSING SLIDE For Frameless Cabinet For Face Frame Cabinet
Applications
Use BP603700112 Rear Sockets
Package contents:
- 1 pair of slides
- Mounting screws
T230M34
| No. | DIMENSIONS |
|---|---|
| T230M34250 | 250 mm / 10” |
| T230M34300 | 300 mm / 12” |
| T230M34350 | 350 mm / 14” |
| T230M34400 | 400 mm / 16” |
| T230M34450 | 450 mm / 18” |
| T230M34500 | 500 mm / 20” |
| T230M34550 | 550 mm / 22” |
| T230M34600 | 600 mm / 24” |
| T230M34650 | 650 mm / 26” |
LIFETIME AND LIMITED WARRANTY
Blum, Inc. (“BLUM”) warrants its hinges against defects in material and
workmanship for as long as the original consumer-purchaser owns the product.
BLUM will send the original consumer-purchaser, without charge, a new BLUM
hinge to replace any defective BLUM hinge subject to this warranty. This
warranty is a warranty of replacement only. BLUM specially does not cover
hinges which have been incorrectly installed, exposed to loads in excess of
specifications, abused or used for purposes other than that for which they are
intended. To obtain a replacement, you should, within 30 days of discovery of
the defect, remove the defective hinge and mail it to the address below.
Enclose a letter explaining the defect, with either the name of the outlet
where the hinge was purchased, or a copy of the proof of purchase. Allow
approximately (4) weeks for delivery of the replacement.
INSTALLATION
To allow the proper functionning of a 230M slide, the exterior width of your
drawer must be 1″ smaller than the interior width of the cabinet, so leave
1/2″ on each side of the drawer. DRAWER PROFILE INSTALLATION INSTRUCTIONS
(SLIDE A)
Position slides with the 90° side at the bottom of drawer while putting wheels
at the back of drawer. Align the front of the slides with the front of the
drawer. Use the screws to attach the slides. DRAWER PROFILE INSTALLATION
(SLIDE B)
The front of the slides must be 1/16″ behind the side of the cabinet (see
illustration). In the case of a sunken drawer front the thickness of the
facade must be added to the minimum 1/16″.
To determine the height of the installation, place the center of your slides
1/2″ higher than the height you require for the bottom of the drawer.
You can now put all the drawers in place and install the drawer fronts. ****
MADE IN AUSTRIA
CHICAGO
Richelieu America Ltd
Customer Service 6350 Church Road
Hanover Park IL 60133
UNITED STATES
www.richelieu.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>