SamKnows SKWB8V4 Nielsen Broadband Panel Installation Guide
- June 3, 2024
- SamKnows
Table of Contents
SamKnows SKWB8V4 Nielsen Broadband Panel
What’s in the Box
Check to ensure you have the necessary parts; which should include:
- 1 x Whitebox 4xAntennas
- 1 x Network cable
- 1 x Power supply
Connect antennas to the back of the White box. (These are used to passively monitor nearby wireless networks for traffic, to ensure no tests are run when the line is active – we do not monitor your traffic)
Connect
If you have a combined modem / router
Connect one end of the network cable to a spare port on your router. Connect
the other end to the blue port marked “Internet” on the rear of the White box
.
If you have a separate modem and router
Keep your NBN connection or modem connected to your separate router as usual
.
Plug in wired devices
Disconnect any other wired network devices from your home ADSL / cable router. Plug them into the ports marked 1 – 4 on the rear of the White box. (Please note the USB ports are non functional)
Powerup
Connect the power supply to your White box. Switch on at the mains socket,
then press the button on the back marked ‘ON/OFF’.
When the light below the ‘-‘ icon remains steady the White box is fully set
up.
Login
Your White box is now ready to start testing your internet performance. You can directly login into nbn-nielsenpanel.com to check the status of your account.
Do not use the product in the environment at too high or too low temperature,
never expose the product under strong sunshine or too wet environment.
The suitable temperature for the product and accessories is 0℃-40℃.
When charging, please place the product in an environment that has a normal
room temperature and good ventilation. It is recommended to charge the product
in an environment with a temperature that ranges from 0℃~40℃. Please ensure to
use only the charger offered by the manufacturer. Using unauthorized charger
may cause danger and violate the authorization of the product and the
guarantee article.
This charger is for indoor use only. The charger type is S24B73-120A200-0K,
output voltage/current is 12Vdc/2A. The plug considered as disconnect device
of adapter.
If you use a third-party charger, the recommended output voltage/current of
the adaptor is 12dc/2A.,and the adapter shall be CE approval type.
RF exposure information: The Maximum Permissible Exposure (MPE) level has been
calculated based on a distance of d=20 cm between the device and the human
body. To maintain compliance with RF exposure requirement, use product that
maintain a 20cm distance between the device and human body.
| Frequency bands | Max EIRP (dBm) |
|---|---|
| WLAN 2.4GHz | 19.51 |
| WLAN 5GHz | 21.15 |
This device is restricted to indoor use where operated in the European
Community using frequency in 5150MHz-5350MHz to reduce the potential for
interference.
Manufacturer
Manufacturer: Sam Knows Limited
Address: Hill House,1 Little New Street, London, EC4A 3TR,United Kingdom
This product can be used across EU member states.
EU Regulatory Conformance
Hereby, Sam Knows Limited Corporation declares that this device is in
compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU.
For the declaration of conformity, visit the Web site https://samknows.com
/eu-certification
Manufacturer
Manufacturer: Sam Knows Limited
Address: Hill House,1 Little New Street, London, EC4A 3TR,United Kingdom
This product can be used across EU member states.
EU Regulatory Conformance
Hereby, Sam Knows Limited Corporation declares that this device is in
compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU.
For the declaration of conformity, visit the Web site https://samknows.com
/eu-certification
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device for operation in the band 5150-5350MHz is only for indoor use to
reduce the potential for harmful interference to cochannel mobile satellite
systems.
FCC ID:2AGPP-SKWB8V4
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>