DONGAR TECHNOLOGIES MY2018 Plus Dash Cam Power Adapter Instruction Manual

DONGAR TECHNOLOGIES MY2018 Plus Dash Cam Power Adapter

INTRODUCTION

Thank you for purchasing theDongar Technologies1O-pin Type B adapter. This document demonstrates installation into MY2O18+ [YOUR MODEL MAY VARY SLIGHTL Y!!J Please review this document in its entirety before attempting installation. Should you feel uncomfortable with the installation procedures, professional installation is highly recommended levels and model year. PLEASE CONTACT SUPPORT@DONGARTECHNOLOGIES.COMFOR VEHICLE SPECIFIC QUESTIONS.

PARTS

1x 10-pin TYPE B dashcam adapter Shorty Micro USB cable and Shorty Mini USB cable

INSTALLATION

• STEP 1: Ensure that the vehicle is completely turned off.
  Performing the installation with the vehicle on may result in a blown fuse or other damage.

• STEP 2: Remove the INNER plastic shroud at base of mirror (see Fig 1).

• Refer to Fig.2. Pry gently downwards at front edge of the mirror cover indicated by

• Hold inner wire cover at edge as indicated by

• Pull towards driver as indicated by

• STEP 3: Remove OUTER plastic shroud. Refer to Fig.3.
  With the inner shroud removed, slide the outer cover toward the front of the vehicles indicated by

• STEP 4: Disconnect mirror. Gently depress plastic tab in center of connector and pull. llo not pull on the harness.
  Refer to Fig. 3 for nondigital mirror connector location. Refer to Fig. 4 for digital mirror connector.

• STEP 5: Install Dongar 10-pin Type B adapter. Refer to Fig. 5. Gently insert male end of Dongar dashcam adapter into connector port. Gently
  insert original mirror harness into female end of Danger dashcam adapter. Route USB output as desired

• STEP 6: Reinstall Outer Mirror Shroud. Refer ,-to ..F.i g.6. Position the plastic shroud against the windshield.
  Slide the cover up towards the roof, ensuring all 4 latches indicated by lock into place.

• STEP 7: Reinstall Inner Mirror Shroud. Refer to Fig. 7. Insert forward end of inner plastic shroud into outer plastic shroud as indicated by
  Holding edge of inner plastic shroud, gently press into outer plastic shroud as indicated by
  ensuring the plastic latches indicated by lock into place.

SUPPORT
Comments? Questions? Installation Help? Email us! support@ddngartechnolgies.com
Like this product? Leave a product review or follow us at:

• DON6ARTECH
• DON6ARTECHNOL06JES

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>