Shenzhen 71101 Building Blocks Toys Instruction Manual
- June 3, 2024
- Shenzhen
Table of Contents
Shenzhen 71101 Building Blocks Toys
Product Summary
Product Description
Smart creative module
Remote Control
Method Of Operation
On/Off
Turn on the power switch and the indicator lights when starting.
NOTE:
Please turn off the power and use it outside. It is forbidden to work for a
long time.lt will stop when the working state is longer than 24 hours, Second.
you need to charge the Smart creative module.
Remote Control Operation
Remote control operation install the battery before using it, the indicator
light will flash. then the indicator will light Long bright.(AAA Battery 2)
Direction button control: Front, Back. Left Right.
NOTE:
When “Front and Back” is pressed at the same time. the indicator light flashes
and the function will be changed. the left and right are the same way.
Link Operation
First turn on the switch of the main control module. then turn on the power
switch of the remote controller. press any key of the control panel. when the
remote controller indicator lights up. the link succeeds.
NOTE
If the product has not been used for a long time. it is recommended to replace
the remote control battery.
Charging Operation
Use usb charging. connect the main Smart creative module and the computer usb
port.When charging.the light on module is on and when full charged the light
is turned of.The charging time is 60 minutes.
NOTE
The charging input voltage should not exceed 5V and the current should not
exceed 1A.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>