amer mounts HYDRA3XL Triple Monitor Mount Instructions
- June 3, 2024
- amer mounts
Table of Contents
- WARNING STATEMENTS
- PRODUCT LINE GRAPH
- TOOLS REQUIRED NOT INCLUDED
- PARTS INCLUDED
- Clamp Installation Steps
- Grommet Installation Steps
- Arm Installation
- Monitor Installation
- Gas Spring Tension Adjustment
- Tilt & Swivel Adjustment
- Cable Management Installation
- Support
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
amer mounts HYDRA3XL Triple Monitor Mount Instructions
WARNING STATEMENTS
- Prior to the installation of this product, the installation instruction must be read and completely understood. Failure to do so may result in personal injury, property damage or voiding of factory warranty.
- Do not install on a structure that is prone to vibration, movement or chance of impact. Reinforce the structure as required before installation. Don’t use the product on particle board.
- The desk clamp can support a maximum thickness of 9 cm. Confirm the desk edge before installation.
- Pay attention to the weight capacity of the mount. Exceeding the limitation can result in function unworkable or even serious personal injury and property damage.
- Never operate the mount if parts are missing or damaged. Contact your local service center for warranty service.
PRODUCT LINE GRAPH
TOOLS REQUIRED NOT INCLUDED
PARTS INCLUDED
Clamp Installation Steps
For desk thickness more than 2.36″(60mm) but within 3.35″(85mm), remove
clamp screw and attachment entirely and reattach clamp screw with bottom plate
upside-down.
Grommet Installation Steps
Remove Clamp from the base
Install Grommet to the base
Arm Installation
Insert extension arms to the supporting part.
Monitor Installation
Recessed surface installation: Put 4 spacers between faceplate and monitor.
Install 4 screws through faceplate, spacers to monitor via mounting holes.
Lift the spring arm along with the monitor and put it on the supporting part.
Gas Spring Tension Adjustment
Use a hex wrench to adjust the height tension of the gas spring arm, to keep
different weight of monitors still at any position.
Tilt & Swivel Adjustment
Tighten the bolt with the Allen Key to make the tilt and swivel adjustment.
Cable Management Installation
Organize cables with cable management clips along the pole.
Support
Amer Mounts
1-800-262-9703
Fax: 1-800-314-6805
Email: sales@amer.com
Technical support
1-888-998-918 9
Email: support@amer.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>