IFIXIT Acer S200HL LCD Monitor ZIF Connector Replacement Owner’s Manual

IFIXIT Acer S200HL LCD Monitor ZIF Connector Replacement

Step 1 — Removing the Stand

• Place the monitor screen face down.
• Firmly hold the base of the stand with one hand and the bottom of the monitor with the other hand.
• Pull the stand away from the monitor.

Step 2 — Removing the Back Panel

• Use the plastic opening tool to pry the back panel from the front panel.
• Start at one point of the gap and pry along the entire monitor to release the clips holding the monitor together.

ATTENTION: There are four clips on both the left and right sides and five clips on the top and bottom.

Step 3

• Gently lift the back panel away from the monitor.

Step 4 — Removing Interior Motherboard Casing

WARNING: Be sure to keep track of where you place your screws. A magnetic mat is great for keeping your screws in one spot.

• Unscrew the four 7.5 mm Phillips #2 screws connecting the motherboard to the metal casing.

Step 5

• Remove the four 10 mm hex screws.

Step 6

• Gently lift the motherboard casing from the monitor.

Step 7 — Removing the Connections to the Motherboard

ATTENTION: The following steps give instructions for removing the three connectors shown in the picture.

Step 8 — Removing the No Fuss Ribbon Cable Connector

• Lift the black seal to release the small ribbon connector (the No Fuss Ribbon Cable connector) from the motherboard.
• ATTENTION: The connector will be released from the motherboard immediately.

Step 9 — Removing the ZIF Connectors

• Lift the black seal to release the large ribbon connector (the ZIF connector).
• ATTENTION: The connector will be released from the motherboard immediately.

Step 10 — Removing the Bundled Cable Connector

• Pull the bundled cable connector gently away from motherboard.

Step 11 — Removing the Motherboard

• Gently lift the motherboard to remove it from the monitor.

Step 12 — Removing the ZIF Connector from the Screen

• Slowly pull the tape off of the ZIF connector and the monitor.

Step 13

• Lift the black seal to release the ZIF connector.
• ATTENTION: The connector will be released from the monitor immediately.

To reassemble your device, follow these instructions in reverse order.

This document was generated on 2021-11-30 10:35:57 AM (MST).

© iFixit — CC BY-NC-SA

www.iFixit.com

References

• iFixit: The Free Repair Manual

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>