Pella Polished Brass Storm Door Outside Handle Instruction Manual
- June 3, 2024
- Pella
Table of Contents
Pella Polished Brass Storm Door Outside Handle
LEVER INSTALLATION INSTRUCTIONS
If replacing an existing lever, reuse the holes from your previous lever. If necessary, drill new holes.
- Cut out the template, then fold and tape onto the door edge, approximately 39-1/2″ up from the bottom of the door.
- Verify the interior lever will not interfere with your entry door. Adjust up or down as necessary to correct for clearance.
- Centerpunch and drill the 5/16″ holes
- Determine yoUI screw and spindle lengths based on your door thickness.
- Rotate the lever for a left or right hinge installation and insert the spindle.
- Assemble the components onto the door and secure the two lower screws (see chart).
- Drill the top hole 3/8″ deep using a 3/32″ bit. Hint: Tv avoid drilling through the door,
- Secure with the upper screw.
- Oose the door and position the strike to make contact with both latch and slide bolts.
- Mark the centers of the slotted holes and predrill using a 3/32″ bit.
- Secure with two screws.
Note: Shims are included if necessflry to build out the strike.
2109 4TH AVENUE SOUTH CLEAR LAKE, IA 50428 USA 1-888-646-5354
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>