ITC 21030 LED Digital Dimmer Instruction Manual
- June 3, 2024
- ITC
Table of Contents
ITC 21030 LED Digital Dimmer
PARTS/TOOLS NEEDED
IMPORTANT SAFETY INSTRUCTION
READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- It is recommended that fuse protection be added to the positive (+) input.
- Determine the installation location and cut a 1-3/8” x 2-5/8” hole. Pull the wiring though.
- Wire the switch based on the wiring diagram below.
- Push wires and switch into the hole and attach using the screws provided.
- Snap the cover plate onto the switch by placing top of the plate over top of switch and snap at the bottom by pushing in on the plate. Test switch. To provide a smooth up-and-down dimming level transition, the switch should be pushed and held. The dimmer will maintain the pre-set light level when turned off and will return to the same setting once the light is turned on again.
Note: A standard rectangular open-face plate can be used in place of the cover plate.
For warranty information please visit www.itc-us.com/warranty-return-
policy
DOC #: 710-00083 • Rev D •11/22/22 3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>